Shopping Cart

Your cart is empty.

Your cart is empty.

Wayne, 1 Count (Pack of 1) 56835-WYN1 8' Piggy-Back Tether Float Switch (Sewage/Sump) Replacement Part, Color

4.3 (8) Write Review
Free shipping on orders over $29.99

$39.80

$ 18 .99 $18.99

In Stock
  • For Sump Pumps or Sewage Pumps up to 1/2 HP, 115V, 13 Amp
  • 8' Flexible Rubber Jacket Cord Operates in Sump Basins 14" or Wider
  • Piggyback plug for SPT, and WST sump pumps, as well as EFL and SEL sewage pumps


Wayne 56835-WYN1 Tether Float Switch For Sump Pumps or Sewage Pumps up to 1/2 HP, 115V, 13 Amp. 8 ft. With Piggy-Back Plug


Charmain Smith
Reviewed in Canada on May 29, 2024
So nice not have to get up at 2am because the sump pump won't turn offEasy to install works like a champ
A. Liu
Reviewed in Canada on December 13, 2024
Very disappointing the float switch is MIC. Wayne prides themselves for being American made.
DeanR
Reviewed in Canada on April 17, 2024
I had one of these before but seem to have lost it?!? Great for adding a float switch to an existing utility pump.
Jack-Eric Vandenbroucke
Reviewed in Canada on August 13, 2023
Fonctionne très bien
Upstateny
Reviewed in the United States on April 22, 2022
I swapped the old non functioning float switch out with the new one on my sewage ejector with no problem except for the water level adjustment. The water level adjustment was a little trickier. Since the new switch is mechanical instead of mercury it is heavier. I had to lower the switch to the top level of the pump on the discharge pipe and shorten the recommended length by one inch.
GriffinWizard
Reviewed in the United States on July 27, 2021
Worked exactly as it was supposed to. I used it in combination with another float switch to regulate the water levels between my well and the water reservoir for an island home. Fresh water is a real commodity during the summer months here and the set up works great.
Customer
Reviewed in the United States on October 9, 2021
Received as advertised
R. Todd
Reviewed in the United States on May 18, 2007
This switch is 115 v.- 13 amp for 1/2 HP pumps. It is the perfect solution to "pump down" requirements such as basement sump pumps or as a replacement for the sump switch. I used it as a switch for a non-submersible sump pump (Wayne 1/2 HP portable utility pump-PC4).There is simply no substitute for this type of switch. It is well-constructed and comes with simple set-up instructions. It works flawlessly in my application.