Your cart is empty.
Your cart is empty.
HLOFIZI 4-1/4 Inch Carbide Grit Hole Saw for Recessed Lights and Dryer Vent, Cuts Through Stucco, Ceiling Old Plaster, Drywall, Sheetrock
Saving your time - Up to 3 X Faster, drilling holes in plaster drywall, fiberglass, ceiling stucco
Package Included:
1 Pc x 4-1/4 inch Carbide Grit Hole Saw
1 Pc x hole saw arbor, 7/16" shank fit 1/2" chuck
2 Pcs x carbide-tipped pilot drills
1 x Allen wrench
Bobby Mac
Reviewed in the United States on January 5, 2025
For the price, you get a great value here because you have the hole saw, the arbor and an extra bit with a masonry tip. I do a lot of recessed lighting in plaster ceilings and this is the perfect answer for getting it done quickly and cleanly.
Scucc07
Reviewed in the United States on January 16, 2025
Works great for canless LEDs, for drywall, plaster/lath it’s amazing, this doesn’t wear out like a metal holesaw. I’ve cut over 50 holes in drywall, plaster/lath and wouldn’t know it by looking at the teeth of the holesaw. I’ve cut one hole thru natural stone tile, it was slow and used water to cool, but it worked. Will work on wood, but takes a little while. Im an electrician and have 3-5/5”, 4-1/8”, 4-1/4”, 6-1/4” and they are all great, the price is also great.
Customer
Reviewed in the United States on August 21, 2024
Works great for recessed lights through hard plaster, just not wood use a regular holesaw. Highly recommend for electricians for the price.
omar
Reviewed in the United States on May 2, 2024
Good product and worked well into hardie board
ms
Reviewed in the United States on November 15, 2024
This works great for drilling thru concrete siding.
Gto4
Reviewed in the United States on October 30, 2024
Fast cutting
ReadwithMike
Reviewed in the United States on October 23, 2024
The cutting edges are coated with carbide, not made of carbide, which concerned me at first. The instructions say to cut at a low RPM, which I did and it cut 3 perfect holes. That’s all I needed it for so it was money well spent.
John C
Reviewed in the United States on April 7, 2024
Worked great to cut though old plaster ceiling. The plaster in my 50s house is a finish coat/scratch coat/gyp board backing that is like concrete that has dulled the teeth right off of bi-metal hole saws before. This hole saw went right through it with no issues and left a clean cut.
Recommended Products
