Your cart is empty.
Your cart is empty.Taurus Mini No Drill and Tap Scope Mount - Silver
Paul Lane
Reviewed in the United States on February 25, 2025
It fit perfectly and attached with ease.
D. Mad
Reviewed in the United States on February 1, 2025
Well made mount, it works as described.
ScoreBooks
Reviewed in the United States on April 5, 2025
It does fit my Taurus .44 magnum revolver
Jason Cline
Reviewed in the United States on February 27, 2024
I had high hopes but fell short, bolt snapped with installing, now have to take to a gunsmith
mikie
Reviewed in the United States on September 4, 2023
Very easy to install took maybe 5-10 minutes. I didn’t have a punch for factory sight used an alien key that was smaller then the pin and a little hammer. Good quality it seems and fits perfectly.
Agapito C. Castillo
Reviewed in the United States on March 23, 2023
Installing a micro dot sight on a Taurus revolver. Installation is easy. The only difficult part was punching out the pin that holds the rear sight to the gun.
Robyn
Reviewed in the United States on November 13, 2023
Packaging good, finish; machining nice. Installation easy, once I got the drift pin out. But that’s not a problem with the mount.
S.
Reviewed in the United States on December 28, 2022
Perfect fit Taurus 608, easy to install not special tool Allen wrench, hammer and flat head screwdriver ( for factory sights) and a 1/16”( I think) punch to remove sight pin
Recommended Products
$13.24
$ 6 .99 $6.99