Your cart is empty.
Your cart is empty.
Toolly 3" Carbide Indexable End Mill, R8 Shank, 5 Flute, w/ TPG322 Inserts
Features
Carbide Indexable End Mills, R8 Shank, 3'' TPG32
Comes with inserts installed
Uses standard triangular inserts
Positive rake 90° right hand cut
R8 Shank
Bridgeport thread: 7/16" - 20
Kenny
Reviewed in the United States on September 29, 2024
Showed up packaged nicely, cuts great, no complaints
Wolfgang Sixl
Reviewed in the United States on May 2, 2024
The media could not be loaded.
Customer
Reviewed in the United States on December 30, 2024
used in aluminum and steelran 1000 RPM and 5 IPM feed
Gregory T Reid
Reviewed in the United States on January 18, 2024
I bought this way back in Aug '22 and am only now getting around to reviewing it. I've used it almost daily through all this time and it's never let me down. I've replaced the TPG322 inserts only once in the (almost) year and a half of frequent use.It works great, can cut reasonably deeply (better with coolant), and leaves quite a nice finish on my steel parts. I'm using a PM-30MV mill and typically run this face mill at 900-1200 RPM for 1018 mild steel, depending on the depth of cut.Of course it doesn't leave a mirror finish as a fly cutter would, but it gets the job done a lot faster and the finish is plenty good enough for pretty much everything I need it for. Recommended.
Recommended Products
$20.99
$ 10 .99 $10.99