Your cart is empty.
Your cart is empty.Condition 1's Airtight/Watertight family of cases are 100% Made in the USA. Made from Polypropylene Copolymer, these cases are crush resistant, and virtually indestructible. This rugged case features an O-ring seal, which makes it Airtight and Watertight up to 3 feet. (Tested for 30 minute period.) The automatic air pressure release valve will equalize the air pressure, which allows this case to be airline friendly! It is ATA/TSA approved. Our unique spring loaded latch system will keep this case tightly closed, while still allowing for an ease of opening. There is convoluted foam glued into the lid, and a removable pluckable foam set in the base will allow you to customize the fit to anything you would like to protect! Inner Dimensions (inches): 18.47 X 13.31 X 6.75.
Michael C. Callahan
Reviewed in the United States on February 10, 2018
tough, dependable, good price, arrived on time
MeTC
Reviewed in the United States on January 6, 2018
Case is ok. However, it seems like there is missing 1 layer of foam. The top of the foam is not at the same level with the case. And the 2 pieces of foam are damaged around the edges. Not a happy camper!!!
Robby W
Reviewed in the United States on May 22, 2017
Significantly less expensive than Pelican; and with as good, or almost as good, quality. The "pick and pluck" foam was relatively easy to shape and the seal seems to be tight. I bought this to use as a camera and accessory storage case and (so far) am well pleased.
Flip on Tech
Reviewed in the United States on March 13, 2017
It was perfect for a custom drone ground station with a sunlight-readable 15" monitor, 12v - 7Ah gel battery, diversity video receivers, patch antenna, extension power cable for antenna tracker, and room for 12' laptop to run QGroundControl or Mission Planner.
Kelly K
Reviewed in the United States on March 13, 2017
Very comparable to a pelican case.... For half the price
Mike Fratto
Reviewed in the United States on December 8, 2017
Not super impressed with the product. It seems like there is a missing section of foam. When I close the lid, there's still 2-3 inches of open space. I'll go get some foam to fill in but it does not look like the product picture.Now, the perforated foam is easy to work with and you just have to be careful pulling out the blocks. The latches lock closed but being black on black, there is no visual indicator that the latches are actually locked in place, so be careful.The case itself is quite sturdy and easy to carry around.
A. lisco
Reviewed in the United States on September 25, 2016
good quality seems rugged enough.....i bought 2 the first one came with a bend in the molding right in the middle by the handle so the water tight seal will probably not work.....I am not going to be using them in water so its no bother...this is NO Pelican case but a good less expensive replacement for one...I would buy this item again...4 stars because the molding process is not consistent
Chris Smith
Reviewed in the United States on October 24, 2016
I did an inordinate (my wife would say "completely unreasonable") amount of research for a "bird-alternative" case for my Airdog drone.This case is both semi-lightweight, but very solid feeling. The included Pick N Pluck foam isn't phenomenal (and isn't a perfect fit for the case), so I ended up using the pre-cut foam that the drone shipped with instead (if you're planning on going this route, you'll need to shave a few millimeters from the handle-side of the Airdog shipping foam).
Recommended Products
$46.15
$ 23 .99 $23.99