Your cart is empty.
Your cart is empty.Kansas City Mike
Reviewed in the United States on September 10, 2024
Makes a beautiful sharp and clean cut for a bevel on my art frames. Would definitely purchase again!
Miguel A.
Reviewed in the United States on May 20, 2024
Excellent Tool!
Aric Farias
Reviewed in the United States on November 7, 2024
The bit arrived in good condition in decdnt packaging. Paint looked good with chips.Edges are plenty sharp and cut adequately.It does take a little prep work out of the package before use, namely you will need to take off the bearing and soak it in something to remove that nasty heavy grease or else it won't spin as freely as it should and will marr up your work piece.Overall, not terrible for the price as leaves a decent finish.
AvgJoe
Reviewed in the United States on November 30, 2024
Stayed mostly sharp through about 500' of 1/8" chamfer on hard maple window sills. Started getting ragged at ~300 ft, but I was able to switch the original bearing out for a larger one, moving the contact edge further up the cutter to allow me to finish the job.
Karl Dysthe
Reviewed in the United States on January 22, 2024
I was happy to get this in one day BUT its not what is pictured , the bearing should be like in the picture, not close to 3/8ths of the shank before the cutting head, Ill have to see if the bearing just needs to be pushed on farther but right now, two stars
mixed up kid
Reviewed in the United States on April 21, 2024
excellent sharp cutter, not perfect for all work. Bearing is farther away from the cutter than it looks in the picture but when used for certain work, it resists clogging, and rough cutting from glue build up.
Fred
Reviewed in the United States on December 13, 2023
I have many Yonico bits. All work great and hold a fine edge. This one fits that pattern. Great tooling with Amazon prices.
globalmarty
Reviewed in the United States on June 6, 2022
Quality and price seem ok. I get a slight edge of laminate sticking proud after trimming with the straight part, so I’m not sure if it’s me (first trimmer bit) or a slightly undersize bit for the bearing dia. It might be better with the bit plunged deeper, to use the chamfered portion, but I was worried about skewing the router and gouging into the laminate. Thus, to be fair, I’d need to experiment some. For now, I’d go for a non-combo bit.
TKN
Reviewed in Canada on November 4, 2022
Bearing is about 7/16” away from blades. Just imagine what is gonna happen if I just accidently off square about 5 degree
Stefan Schilling
Reviewed in Canada on February 23, 2018
Good toolWorks great
Customer
Reviewed in Canada on December 4, 2017
Its great. Can't comment on longevity but it works as it should so far (light duty use).
Recommended Products
