Your cart is empty.
Your cart is empty.Product Description
WADEO Brass Rain Barrel Quarter Turn Ball Valve Spigot with Bulkhead Fitting
How to Install
Step 1 : Drill a 1 inch hole.
Step 2 : Drop the fitting male piece inside.
Step 3 : Pick up the fitting from outside.
Step 4 : Tighten the nut.
Step 5 : Wrap with thread tape.
Step 6 : Tighten the faucet clockwise.
There are two ways to install it .
KP
Reviewed in the United States on February 2, 2025
Works great!
Rochelle
Reviewed in the United States on September 26, 2024
Super simple install in stock tanks. No leaks
RegularShopper
Reviewed in Canada on September 20, 2024
It works as described and seems to be machined well. It was easy to install and the finish was nice. Happy with my purchase.
M heebs
Reviewed in Canada on September 15, 2024
Had no issues getting this set up. Works like it should.
Ross T. Guillermo
Reviewed in the United States on August 7, 2024
I installed it in my 3 55 gallon barrel then using them as a rain barrel to water my backyard gardens! Very helpful and handy especially when you just connect the hose
Paul_S
Reviewed in Canada on June 17, 2024
Everything thing worked out fine. It even came with thread tape.
Stephen C.
Reviewed in the United States on June 15, 2024
Easy to instal and sturdier than the plastic version. I installed them on the bottom of stock tanks to pull water out of the bottom (while another hose puts water in the top) to keep it from going stagnant or filling with duck poop... (I wonder if Amazon will censor that...)
Linda Pierce
Reviewed in the United States on November 21, 2024
Easy to install, perfect fit, easy to open and close
Jake J.
Reviewed in the United States on November 16, 2024
Replaced an old spigot that was leaking. No issues.
Jessica Korzyniowski
Reviewed in the United States on November 14, 2024
Finally, a spigot that fits my Tartar 100 gallon metal stock tank. No leaks. The threads were snug but appropriate, and ultimately it threaded and smoothly after a little WD-40 was applied. Well worth the money.
GARY MEYERS Retired mechanic/handyman.
Reviewed in the United States on October 24, 2024
Less water spilled using spigot, in stead of dipping out of rain barrel .
Customer
Reviewed in Canada on April 4, 2024
Built a rain barrel for the flower garden, simple install with sturdy parts.
Nate
Reviewed in Canada on May 18, 2023
It's a nice looking good quality ball valvespigot, comes with bulkhead fitting and two silicon washers. In my case I installed this item in a blue plastic barrel and found that the washers either squished too much and leaked, or leaked because they weren't right enough. I used some good outdoor silicone caulk under the washer, and that seems to have fixed the problem. I would purchase again
Recommended Products