Your cart is empty.
Your cart is empty.White Cloud Traveler
Reviewed in the United States on March 26, 2025
I found it to be very useful when removing ICs and components from a multi-layer circuit board. It works well on through-hole soldered parts and surface mount parts.
B. Brumfield
Reviewed in the United States on February 4, 2025
I needed this to assist with the removal of surface mount chips, and it worked perfectly.
Brett C.
Reviewed in the United States on February 2, 2025
This really helps remove chips at a low temperature without overheating or lifting circuit traces.Problem is, you may run out of the alloy quickly. I think they should give you more for your money. I had to purchase a second kit.
Neptune
Reviewed in the United States on January 5, 2025
It has never failed to work, or get me out of a pinch.. Stop burning SMD components and get a helping hand with this stuff..Use as little heat as possible.. it'll make it easier to work with and get into the small HDMI port legs etc.Only use as much heat as needed, and work this stuff into the old solder and it'll make removing any SMD part a breeze. The included flux, was good enough I wanna try a full syringe of it now, and see how it comapres to the very expensive Stirri I use. Chip Quick, is uickly becoming a dominant force in products when it comes to repair specialized tools, equipment and supplies, and honestly if they continue to keep up the great quality, and keep prices fair they will become the "Go To" for technician and repair supplies. -Neptune_Labs
KFZ Meister
Reviewed in Germany on December 29, 2024
Das Flussmittel ist nicht gut, das klebt wie Sau. Meiner Meinung nach nicht zu gebrauchen, das Lötzinn ist okay
Anthony C.
Reviewed in the United States on December 1, 2024
Wanna know what they use in those YT videos that shows how someone can wet the chip connections on all four sides with a simple soldering iron and then lift the chip off the board so quickly? This is it. The eutectic alloy additive lowers the melting temperature of the solder keeping it wetter longer with lower heat. This makes it easier and less stressful on the board and pads when removing SMD chips with side pin leads or contact pads. Surprising a little can go a long way and leftover slag can be reused to help de-solder other chips. Cleaning is also generally easier as well.
ian
Reviewed in the United States on September 11, 2023
This stuff allowed me to rescue a surface mounted PCB from another one. It worked great, and took less than 10 minutes to do.
CreativeGuy
Reviewed in the United States on April 29, 2023
The media could not be loaded.
Don
Reviewed in the United States on February 19, 2022
This product works wonderfully when used according to the instructions. By lowering the melting point of the solder many types of parts are easily removed without special equipment. Then clean up the board and you can easily solder new parts back onto the board. The paste flux provided is wonderful and the board cleans up nicely after the faulty part is removed.
Recommended Products
