Your cart is empty.
Your cart is empty.The ETN Series, Solid-State Flasher, Time Delay Relays, have 2-wire leads (Series Connection with Load), are totally encapsulated circuitry, has a molded case with built-in mounting feature and has high inrush capability. This series is low cost, and has 1 Amp (Full wave) and 3 Amp (half wave) versions. When supply voltage is applied, the OFF delay (T1) begins. Upon completion of the OFF delay, the load energizes and the ON delay (T2) begins. Upon completion of the ON delay, the load de-energizes and one cycle is complete. This ON/OFF cycling continues until the supply voltage is removed. The OFF delay always equals the ON delay.
Twin Otter
Reviewed in the United States on November 12, 2015
Used In a parkade flashing red light indicator and works very well. Used with LED bulb and flashes between very low intensity and full intensity. Does not switch completely off at least with LED used. Far better than the factory flashing circuit included with the Edwards fixture and cheaper too.
Recommended Products
$14.59
$ 7 .99 $7.99