Your cart is empty.
Your cart is empty.End mill engineered for aluminum cuttijng perfection.
roy c kohl
Reviewed in the United States on May 26, 2021
works GREAT !
Slicingblade
Reviewed in the United States on November 29, 2021
Sharp like razor blades these endmill leave a mirror finish.I've been running the recommended feed&speed of 25% woc, 100%dia doc doc @99.2ipmAlso sharp like razor blades they will cut you as well.
Customer
Reviewed in the United States on January 5, 2021
YG-1 makes great cutting tools, you can't go wrong with them. These are very very sharp, use the supplied cap when installing or removing these from a mill. Highly recommended cutter.
Eric Larson
Reviewed in the United States on January 29, 2021
Yes. If you are reading the reviews to see if you should purchase this for ANY project... 80%’s especially... the answer is yes.
APClam
Reviewed in the United States on October 25, 2020
Cuts through 6061 like butter. Leaves a very smooth cut. This is one beautifully made end mill and it’s true you get what you pay for.
April Gerry
Reviewed in the United States on January 23, 2020
These are fantastic endmills. I run the 3 flute carbide endmills for roughing and finishing in my 40 taper VMC and get unreal tool life, 10s of hours in the cut with very minimal wear and great surface finishes. For aluminum I prefer these over other major brands such as Garr, Harvey, etc. Cant beat em, great carbide, highly reccommend.
Customer
Reviewed in the United States on August 16, 2018
They’ve become my go to endmill. Proper handling, they last.
Paul M.
Reviewed in the United States on March 26, 2016
Worked like it should!!
Recommended Products
