Your cart is empty.
Your cart is empty.This bit has a cutting diameter of 1/2" And a cutting depth of 1/4". The bearing has a diameter of 5/8" Which helps preserve the template. The shank diameter is 1/4". Especially designed for hinge Mortising templates, This offset template trim Bit will allow you to route corners with radiuses as small as 1/4". The larger bearing distances The blade from the template, shielding it from any unwanted trimming. Offset flush trim router bits are used to get an even smaller corner radius than the shank bearing would normally allow. The cutting diameter is smaller than the bearing diameter and therefore some compensation is required when making your templates. These bits are commonly used for hinge Mortising and small solid body guitar cavities. Flush trim template router bits work in your router Table or handheld router. Secure your template to the top face of the work for handheld operations, or to the bottom face of the work when using a router table.
DM-SEMPER
Reviewed in the United States on September 9, 2024
The media could not be loaded.
J. D. Peringer
Reviewed in the United States on June 5, 2024
While I've only used this bit a handful of time, it has performed as designed. I would recommend it.
Martin C.
Reviewed in the United States on December 24, 2024
I bought the Porter Cable Hinge cutting system and the router bit that came with it was dull after one door and did a terrible job cutting, but I really liked the template. This bit was a game changer and made the system so much more effective. I've cut four doors with it and its going through like butter and nice clean cuts.
Dana Scott
Reviewed in the United States on July 21, 2023
Nice clean cuts in softwood. Bought for routing latch plates in doors, working fine, cutting well.
R. Marks
Reviewed in the United States on October 23, 2023
I have bought many Yonico bits. They work very well for the price
Socal951
Reviewed in the United States on August 4, 2022
Good buy does what it's supposed to.
Customer
Reviewed in Canada on August 23, 2021
Using it to cut soft lumber. Works well, clean cuts.
Thumbs
Reviewed in the United States on August 7, 2020
Works great with my cheap door hinge jig. I've used it on 6 doors so far. Still is sharp and cuts great. This is an offset bit.
Bob
Reviewed in the United States on October 26, 2020
Closeness between bearing and cutting blades. This small gap makes it easier to cut thin materials when using thin patterns.
Recommended Products
$75.98
$ 34 .99 $34.99
$42.38
$ 18 .99 $18.99