Your cart is empty.
Your cart is empty.charlies
Reviewed in the United States on March 20, 2023
Works great, very well made and stays sharp
Meagan
Reviewed in the United States on May 21, 2021
Great tool exactly what I needed!!
Tanman762
Reviewed in the United States on February 3, 2020
Great for the lower 80
Bill
Reviewed in the United States on September 13, 2019
Ok
Art
Reviewed in the United States on March 5, 2015
Super sharp and did the job perfectly. I used it on an ar 80% lower for the trigger pocket and I had plenty of clearance between the drill press chuck and the top of the receiver.
M. Bernstein
Reviewed in the United States on September 23, 2013
really like the extra long shank! This comes in handy for those really deep relief cuts in materials over 1 inch thick.
millerized
Reviewed in the United States on April 24, 2013
The longer bit is needed for an application, but the speeds need reduced because of deflection. Nothing an experienced machinist can't figure out on his own. Sharp, and they do just fine in 7075-T651 blocks.
Recommended Products
