Your cart is empty.
Your cart is empty.Product Description
IPSC Target: 18 inches wide x 22.4 inches high - 3MOA Vs 6MOA
Ensure the footprint is carefully chosen
c sanantonio
Reviewed in the United States on January 3, 2025
Very easy enough to install and setup on top of my Vortex Spitfire. I zeroed it at 15 yards for CQB. It holds zero after 200 rounds in the range. I will definitely buy it again. I got a lot of compliments on the first day I took it to the range.
Bo
Reviewed in the United States on January 12, 2025
Got about 100 rounds on 9mm. Surprisingly good!
john doss
Reviewed in the United States on September 15, 2024
This is a good general purpose sight. I mounted it on my 20 gague Mossburg and it fit like it was made for it. There is one thing you need to be aware of: this sight does NOT come with a battery installed or even included. Make sure to have, or order, a Cr 2032 battery when you order the sight. I will update this review after I've shot a box or two of shells.
Customer
Reviewed in the United States on March 2, 2023
As somebody else stated, the footprint is it’s own unique footprint. Its similar to a Leupold Deltapoint footprint, but not quite there. That being said, I had no problems mounting this to a Shadow Systems XR920: I’m fairly sure that if you have a MOS cut, you should be good to go. Dot was clear and visible on a sunny day and retained it’s zero after 500rds.Pros:- Budget oriented- Reliable (in my case, for at least 500rds so far)- Visible dot, solid brightnessCons:- Unique “Vector” footprint- Windage / elevation adjustment has no tactile or audible click (it slightly bothers me, but had no effect on performance)
Doctormdds
Reviewed in the United States on March 18, 2023
I have found a reasonably priced red dot to replace the problematic Crimson Trace that came with my handgun. This Vector Optics fit perfectly on the Picatinny rail. Sighting it in was easy and I found the adjustments to be consistent. Once it was sighted in I found the dot to be easy to see and it held its zero. The buttons responded as they were designed to. This Vector Optics doesn't have shake awake and it doesn't have a solar backup but I knew this going in to it. This unit was bought for my rimfire handgun and it does it's job just as it should. The price is right and it has a lifetime warranty. I would definitely buy it again without hesitation.
TDubs82
Reviewed in the United States on October 5, 2023
Vortex has stood the test of time. There are many optics that are out there that are just as good, or maybe even better because of features and different styles that are relevant, etc. This one was perfect for my needs. This fit on a Canik Mete SFX, and I did not have to remove the rear sight, which was very important to me. Attached on perfectly, and did not have to adjust the zero when it came out of the box. Still very much quality made, and I took it to the range and shot 250 rounds no problems. Didn’t bounce, go out to zero, and operated flawlessly. Very happy with the purchase. Came on time, and assembly was less than 15 minutes to put together. Good luck!
Ryan D. Crompton
Reviewed in the United States on October 26, 2023
I put this on a Ruger MKIII 22/45.Goods: Fairly easy to mount. Held zero, albeit it's just a .22. Fairly tightly manufactured from the factoryCould go either way: On/off is always a sore point with any reflex sight. This turns on to the last setting. Some of these have auto-adjust, though mine didn't. Buttons are on either side. No shake-awake.Bad: Another device that requires three wrenches to mount, put a battery in, and sight in. Wish somebody would take a page out of Spyderco/Trijicon's book and just use hardware that can be turned with a penny/quarter/knurled knob.For my use case, it's fine. I don't know if it's trust this with a PCC or something heftier. Adequate for range use.
Luke W.
Reviewed in the United States on January 18, 2023
Just like the header says this does not have the footprint for rmr. They don't say this anywhere in the production description, all they say is "it's vector foot print" which doesn't really help. and now I have to spend time and money making a return.... So if you're buying this to be used as a red dot for your pistol shop elsewhere... Waste of my time.
Recommended Products
$329.99
$ 99 .00 $99.00