Your cart is empty.
Your cart is empty.Jerry Zeppelin
Reviewed in the United States on May 15, 2023
Been in the machinist trade since 1977.....I know how to use an end mill. This thing wouldn't even cut plastic stock! the cuting edge is too far towards the cutter center it seems, it's like using a burnt up trashed cutter. Sorry. we have many of these at the shop.This is just plain poor manufacturing. Save yer dough folks
D.O
Reviewed in the United States on May 19, 2021
Good
kenneth hayes
Reviewed in the United States on February 17, 2021
perfect for softer metals, planning slots in pincatinny mount
mark grove
Reviewed in the United States on April 29, 2021
It works well
roger crary
Reviewed in the United States on August 3, 2020
It cut right to size, would like it to stare sharper a little longer. Will buy again
Recommended Products
