Your cart is empty.
Your cart is empty.With two (MR2) pre-drilled faucet holes . Maximum 5 Faucet Holes. 16 gauge 304 stainless steel. Brushed finish with highlight rim. 3mm sound deadening pads. Superior undercoating for added sound insulation Fits 36” minimum base cabinet width. Rim of the sink sits on the countertop.
D & D
Reviewed in the United States on June 28, 2024
PROS, very nice looking sink, heavy duty for 3/4 HP garbage disposal, nice finish, would recommend this sink 100%, if the company's quality control department takes some pride in their products, see belowCONS, now I gave this a 5 star so you will read this, it came well sink was packaged in cardboard box and appeared to be well protected from delivery issues, that's my issue. First after removing the sink my wife noticed a dent in on the outer lip. I looked at the box again and there where on damage to the box so it must of happened during packaging and not damaged by the shipper. I was able to use the correct tools to remove the dent as if it was not there. Put the sink into the cutout and it appeared that the sink was warped. Would not lay flat, so pulled it out and I saw a small spot of orange paint sprayed on the bottom side of the sink. Looking closely I observed that the corner of the sink was also bent but in a larger area. This disappointed me as this defect was spotted by an inspector and marked but not corrected. I again corrected the bend. After that I installed the sink and it now looks great. I would recommend this sink, but quality control needs an ass chewing for letting this sink go out in the condition I received it.
Silvertabby
Reviewed in the United States on May 28, 2024
Made in Thailand, this Transolid Meridian” 22” x 33” x 9” double-bowl, 16-gauge, stainless steel sink is commercial quality compared to similar major brand sinks costing twice as much, or more, made from thinner 18 or 20 gauge stainless steel that are shallower.Though out of stock, before being discontinued at the orange big box store’s website, this sink popped up a month later on Amazon.com for $20 less, so I jumped on it!I read many one-star reviews about these sinks arriving with bent corners due to being dropped and damaged in transit during shipping, then having to be returned and reordered as many as three times, before receiving one undamaged, but I took a chance, because I wanted commercial quality. Fortunately, my sink arrived in perfect condition.I like the perimeter water stop that runs behind the rear “shelf”, so water from wet sponges, dishrags and scrub brushes set thereupon, drains back into the sink, instead of onto the countertop. I like the 9” depth to accommodate big pots and to contain overspray when using the power wash option on the pull-down spray head on our new faucet. The brushed finish is a bit coarse, retaining a dirty film, unless scrubbed with dish soap and rinsed after rinsing or washing dirty dishes. The mounting flange is flat and stiff, so it seals well to the countertop surface, but the included stick-on foam tape perimeter gasket is not wide or thick enough to adequately seal the flange lip, so I set the sink into the countertop hole, traced a line around the lip edge onto the countertop, removed the sink and masked around outside the line before running a small bead of marine-grade silicone between the gasket and the mounting flange lip for a positive seal when mounted and clamped down in place with the ten included mounting clips installed from underneath the countertop. I broke off the ears on the screwdriver slot tightening the last mounting clip. A male Allen (hex-drive) head would be much better than the thin, fragile straight screwdriver slot. The sound-deadening pads glued under the bottom of both sink bowls eliminate any noise while washing dishes or running the garbage disposal. The drain opening flange in the bottom of both sink bowls are convex, so it forces the rubber sealing gasket away from around the drain fitting neck when tightening the compression ring nut, but the ring of plumber’s putty under the drain fitting mounting flange, seals them from above, inside the sink.
A. B.
Reviewed in the United States on January 11, 2021
Very happy with this product. Got a warehouse deal and primarily chose it for the good deal, the fact that it has identical measurements to the one we just replaced, and that my dad said “you can’t go wrong with stainless” meaning no need to look for a certain name brand for a sink if the materials are good.I feel that it looks more expensive than I got it for and even though our old sink was also 9” deep, something about the use of space here makes this sink feel deeper!I was wary about bent corners and was pleased that it arrived in good shape.I still am wary about any rusting but we will be careful of it and if it starts rusting I will certainly update. The stainless steel brushed finish is a little rough so I think if it does rust it will be due to that.The internet says not to use bleach on it or any steel wool or steel scouring brushes, and not to leave metal soaking in it for long periods of time. I’m choosing not to leave, for example, aluminum cans to be rinsed out for recycling to sit in there for extended periods of time and stuff like that. All a sink like this needs for cleaning is soap and water and for extra points you can dry it and shine it up with some olive oil on a microfiber cloth.P.S. when installing do not forget that the brackets are in a small box in the corner of the large box the sink comes in!
Recommended Products
$136.50
$ 64 .99 $64.99