Your cart is empty.
Your cart is empty.Grips: *Made in the USA! *Perforated wrapped grip that provides great all around performance. * * * * * * Clamp: * Full Size 3.5 inches *Diamond channel locks shaft in place *Side ribs increase friction in vise with less pressure * * * * * High Quality Rubber Tape: *Premium Double Sided Golf Grip Tape Strips for Regripping Golf Clubs *2" Wide x 9" Long - Exact Width and Length for Easy Gripping *Tape is 7mm in Thickness - Standard for Golf Grip Tape *Easy to Peel Strips Saves Time *Made in USA!
all_stater
Reviewed in the United States on March 20, 2025
Nice looking grip, feels great but the are about "just" barely larger if any than many of my other standard grips.
GWB
Reviewed in the United States on January 17, 2025
Excellent quality, installs easy and feels great.....I've got a notion these will last a LONG time on my irons !!!
CJB.
Reviewed in the United States on July 28, 2024
The tape is of low quality. I tried putting two grips on with the tape provided and I just barely got the second one on. I used tape I had on hand and it worked a lot better. I could tell the grips are lower quality than other brands I have put on clubs. They seemed flimsy which made it harder to put them on. They are good as far as when I played a couple of rounds with them. I have used other brands I liked better but at this price they still do what I want them to. I will have to see how well they hold up.
Kindle Customer
Reviewed in the United States on May 12, 2024
fell good in your hands,tape is thin but easy to install if you are careful, it holds very solid and does not add size to the grip.
GreenEng
Reviewed in the United States on October 29, 2022
I had never installed grips but I decided to go for it. I used compressed air with needle type pistol grip gun to assist (recommended if you have a compressor). The tape supplied is a clear thin type, not the masking tape type traditional masking tape looking stuff. It seemed perhaps less stable and more difficult to work with, seemed to want to come apart as the grips went on (and I suspect will be harder to remove) - so I think I would have preferred "normal" tape, but it was useable. I used "California type" low VOC paint thinner which turns out isn't very slippery (more like acetone), which I think made the job more difficult than it should have been, I would try specific grip solvent or something else next time. The grips feel great - I won a tournament after re-gripping my irons! Durability TBD.
William in Bama
Reviewed in the United States on April 12, 2022
I like the feel of these grips a lot. A friend and I used an air compressor to install the first one. The 2nd one we had too much air which we blew out the grip and destroyed it. These were by far the most difficult I had ever worked with. Just too tight, Don't be afraid to use some solvent and make sure you ease the air into the end of the grip if using the air compressor method. I normally regrip clubs by myself, but due to the tightness of these grips, these seemed to go on better with two people.
A. Kost
Reviewed in the United States on August 31, 2020
I am not sure that I understand why there is such a tough time putting these grips on. I plugged the hole on the grip with a t pour a little solvent into the grip and rotated around then put the solvent back into the bottle then spray the tape well and they go on easily for me. Was very impressed with the tackiness and the feel of these grips. Right now I cannot justify paying over double the price for golf pride tour wraps which feel virtually identical to these!
M. B. Skibesky
Reviewed in the United States on October 9, 2020
I got these for a set of Spalding clubs I bought in 1980 that I recently restored. Wanted something good that kept the old nostalgic wrap look while keeping the cost down. I was going to use the same GP wraps that I use on my newer clubs but went with these on a friends recommendation (despite the many negative reviews regarding quality and difficult installation). I'm glad I listened to my friend. The grip kit I received was exactly as described and arrived 3 days early. The grips measured the same as my GP midsize and I found them to be of the same general quality. I had no problem what so ever with installation. Coated the tape AND the inside of the new grip with solvent, carefully worked the open end of the grip onto the end of the shaft and it firmly slid on until properly seated. I found the installation no more or less difficult than with any of the other major brands that I have used over the years. The reviewers who tore and destroyed grips and were just not able to install them had to be doing something wrong. There is a knack to installing grips, and they are not suppose to just slip on like a banana peel there is suppose to be some mild pushing and slight twisting involved so when the solvent dries after several hours the grips are firmly in place. As far as the quality goes I found it very good. They have a firm base but are soft and tacky when held. I just used them for 27 holes and really like them. Another plus for me is that they are made in the USA. I would definitely buy them again.
Recommended Products
