Your cart is empty.
Your cart is empty. Type
4 Flute End Mill Bit
Dimension
Cutting Dia:7/8"/22.5mm
Shank Dia:3/4"/19mm
Cutting Depth:1-1/2"/38mm
Total Length: 4"/102mm
Package Content
1pcs x End Mill Bit
Please Note
1.Stop immediately in the processing of anomalies when using the end mill bits and find out the reason before processing.
2.Pay attention to the condition of wear and tear of the cutting edge and timely repair the end mill bits.
3.Cleaning the end mill bits and use oil after using, keep end mill bits properly.
4. The drill bit might be overheated and get damage even burned out due to rotary friction so coolant is necessary when drilling.
Edward E. Schwall
Reviewed in the United States on January 29, 2025
End mill was advertised as 7/8 diameter with 3/4 shank. End mill was actually 22mm diameter (.866) and shank was 20mm (.787). End mill shank was marked 7/8. Would have been an ok purchase if you have a 20mm r8 collet.
Kindle Customer
Reviewed in the United States on January 25, 2024
Advertised .750 ....needed that for mill collet. Actual size is 0.7865. Cutting dia. is approximately .875 (7/8).
David Hale
Reviewed in the United States on August 15, 2023
This is NOT 3/4 inch shank. It's 20mm and will ONLY fit in a 20mm R8 collet. Will NOT fit in 3/4 or 7/8 end mill holder.
David Riebau
Reviewed in the United States on April 26, 2023
End mill had damaged flutes and wouldn't cut. Four knicks and worthless. I won't buy from them again.
Recommended Products
$11.67
$ 5 .99 $5.99
$36.95
$ 17 .99 $17.99