Your cart is empty.
Your cart is empty.With 50 years of experience and known as the recognized leader in North American Floor Care and Surface Protection products, Shepherd Hardware manufactures a full line of quality products. Product range includes casters for furniture, office chairs and industrial purposes, lawn, garden and commercial replacement wheels, dollies for small or larger loads, rubber cups, bumpers and tips under stools and furniture legs, glides for multiple surfaces and the best-performing felt products on the market. Global headquarters in Michigan allows for consumer-driven on-shore product development while strong overseas supply chain operations support consistent quality and value.
Junebug
Reviewed in the United States on July 21, 2024
Theses are perfect for my old heavy ironing board. They were a bit tight putting them on, but my ironing board has been painted & has that extra layer of paint. Anyways, they’re on nice & tight & won’t be slipping off.
Ken in Denver
Reviewed in the United States on June 10, 2024
I have a kitchen with wood floors and heavy bar stools with steel legs ending in 1-1/8" diameter steel feet. They had felt pads on the bottom, but those were catching and keeping grit and scratching the floor so I bought these. They are just flexible enough to get over the feet and then hug tight. The 1-1/8 size fits tight - it would not fit anything bigger than 1-1/8. They are "rubbery" enough to allow pulling the chain over the wood floor, but not so "rubbery" that you'd have to actually always pick up the barstool to move it like some of the clear silicone ones I tried.
Cherry
Reviewed in the United States on November 28, 2024
Great but measured wrong so they did not fit. My bad.
Jennessa
Reviewed in the United States on December 29, 2023
Broke right after being put on. Very cheap plastic. Would have been better if was made of different type of plastic, one with a little more elasticity in it not this flimsy crap.
Philip
Reviewed in the United States on November 8, 2023
Fit perfectly, just had to lightly tap it on with a small hammer. Good value for the money. Holding up well so far.
Rhode Man
Reviewed in the United States on October 15, 2023
I had speaker stands with missing feet. They were relegated to "the pile" of retired equipment, because I did not want the bottom edge of the metal legs to damage floors in the venues I play. So, I bought these feet to replace the missing ones, and now I can use the stands again. They fit perfectly. They are easy to install. You start the foot onto the leg, and tap it into place with your hand, or maybe a hammer. Once they're on...done. they stay put. Good product.
Jables
Reviewed in the United States on October 4, 2022
Bought to soften the end of a closet rod. Went right on and works great! Does add a bit of length to the end and makes the rod fit a little snug now, so I might take a little bit of the edge off to account for these adding 1/4 inch or whatever they add. But that was to be expected. I've taken one side off and put one of the furniture felts in there in the meantime. All good!
Young Jedi
Reviewed in the United States on August 4, 2020
I bought these leg tips as replacements for an old rocking horse we pulled out of retirement. They don't make them like they used to anymore. The tips were all cracked and worn on the ole timer. I replaced the leg tips on that touch the ground with rubber tips. I couldn't do the same with the top part of the metal because of where the springs are connected. The rubber ones were a bit long. I had read from other reviewers that if you warm these plastic tips with hot water they would go on easier. I took that advice and darn if the first three didn't go on well. However, the last one was a bit tight so I warmed it up again and tapped it with a rubber mallet. That was not a good idea as with just one soft tap the leg tip broke in two. Darn! I ordered another four pack so I can finish the job. Overall I am happy with the product as it will do its job and cover the metal opening. I gave it four stars because it was not easy to install. If I hadn't warmed the plastic up with warm water i believe all four pieces would've probably broke.
Recommended Products
