Shopping Cart

Your cart is empty.

Your cart is empty.

Metal Steel 32P Pinion Gear 3.175mm Shaft 10T 11T 12T 13T 14T with Hex Key for RC Brushless Brush Motor RC Car Upgrade Part A

4.9 (3) Write Review
Free shipping on orders over $29.99

$14.58

$ 6 .99 $6.99

In Stock
  • 【Compatible with】3.175mm Shaft Size Motors(Compatible With 550 540 3650 etc motor) make sure your RC motor shaft have the same diameter
  • 【Spec】32 Pitch pinion gear 3.175mm 10T 11T 12T 13T 14T
  • 【Material】Made of Hardened Steel to increased wear resistance and improve fatigue life,make them roll smoothly, it will work with the steel spur gear. did not work with plastic or aluminum spur gear
  • 【Size】Height:11mm/0.43inch Comes with screws for each pinion gear
  • 【Package】32P 3.175mm shaft 10T 11T 12T 13T 14T pinion gear and a hex key


Description:

Metal steel to increased wear resistance and improve fatigue life

Nitrided to enhanced hardness corrosion resistance

Tooth count: 10T 11T 12T 13T 14T

Tooth pitch: 32 pitch

Height: 11mm

For shaft: 3.175mm


Package include:

1 X 32p 10T pinion gear

1 X 32p 11T pinion gear

1 X 32p 12T pinion gear

1 X 32p 13T pinion gear

1 X 32p 14T pinion gear

5 X Screws

1 X Hex Key


Make sure you thread lock the grub screw. They are hard to find when they fall out.

Larger gears will result in higher speeds while smaller gears provide more torque.

For quicker acceleration go for a smaller pinion gear (with fewer teeth) and larger spur gear (with more teeth).

Your car will accelerate off the mark very quickly with more torque, and you'll also benefit from cooler running temperatures, extending the life of your motor and ESC.

How to install the pinion gear:

You will probably need to loosen the motor a bit, in order to fit the pinion gear on. Make sure you lock it in place on the flat portion of the motor shaft.

When you are tightening it back up, make sure you leave about a gap between the pinion gear and the spur gear. That gap will be very small. It should be about the thickness of a piece of paper.


supersteve788
Reviewed in the United States on July 25, 2024
out of the 5 gears i have used 3 and all 3 stripped pretty much instantly. they need to discontinue manufacturing these P.O.S.'s. Such a letdown. I spend all that time removing the old and installing the new just to have to do it all over again right after I get my rustler reassembled. itd be nice if I could get a refund. after the 3rd gear stripped I lost ambition to even want to drive my rustler because of this.
Customer
Reviewed in the United States on March 24, 2024
In a vxl slash the 12 tooth broke on first use. In a rustler the 11 tooth lasted about 2 minutes. We will be looking for a different brand.
shawnessy enterline
Reviewed in the United States on March 2, 2024
They do not mesh smoothly.