Your cart is empty.
Your cart is empty. Are you looking for universal upgrade 48p 5mm pinion gear set for your RC car?
Our 48p 5mm pinion gear set will be good addition to your RC car toolbox!
And you will like the option of being able to change your gear ratio for different track conditions.
With the shaft coupler you can also use a 5mm shaft RC motor and a 3.175 shaft RC motor.
With the hex key in the package, you can keep the screws tight on your motor shaft, affordable set to dial in your gearing.
Package include:
1 X 23T 48p 5mm pinion gear
1 X 24T 48p 5mm pinion gear
1 X 25T 48p 5mm pinion gear
1 X 26T 48p 5mm pinion gear
1 X 5mm to 3.175mm shaft coupler
1 X Hex Key
10 X Screws
Ron
Reviewed in the United States on March 18, 2025
As described
Vicious cycles
Reviewed in the United States on January 7, 2025
I snagged these to keep around ofr spares.They can in very handy today when i decided I wanted to motor swap my Associated Hoonitruck.The truck comes with a 22 T so I jumped up 1 to try a 23 and test heat from there.Overall Nice qualityFit the Hobbywing more without an adapter needed, and would have fit the REEDY motor if i wasnt removing it.The grub screw is solid, didn't have any slippage of the wrench at all and it locked down firmly.Overall Im super happy with these Pinions, and its really a great value, especially with the adapter Included.
Michael
Reviewed in the United States on January 6, 2025
Priced well and seems well made.These fit my hobbywing 3665 motor with a 5mm shaft.It also comes with a mn adapter for 3.175 shaft which is another plus. Great value.
Joe Mulvaney
Reviewed in the United States on September 26, 2024
Impressive for the money. Good packaging and came as described
Bracket
Reviewed in the United States on September 1, 2024
Most cars that use a motor with a 5mm shaft also use 32dp or module-1 gears. But I have an old Durango truck that uses a 48dp spur gear with a 550 motor, which means these gears are the perfect solution.The machining looks clean and the laser etching is solid. I did not notice any abnormal gear noise or wear on the teeth after running a pack through the car with one of these pinions installed.I did not need to use the included motor shaft adapter, but I am not sure I would trust it. The fit is a little too loose. Tightening the setscrew when you install the pinion will take up any tolerance in the joint, but then the gear will be slightly off-center on the motor shaft and could cause premature wear or failure. Plus, you only get one adapter. If your motor has a 3.175mm shaft, just get 3.175mm gears.
Recommended Products
