Your cart is empty.
Your cart is empty.Product Description
Kowood Pro Designed and maufactorated to eliminates friction and chatter. Fit most table router with 1/2" shank size
Kowood Pro design shear angles with Mirror finish for chip clearance
Razor sharp cutting edges for smooth cuts with KOWOOD C3+ Grade Carbide
New design, choose from carpenter, essential set for woodworking
Nadav Shalit
Reviewed in the United States on September 4, 2024
The best result I've seen so far for curved walnut. Haven't tried on maple and such. Very affordable.
J. Powers
Reviewed in the United States on February 22, 2024
This thing is a beast of a router bit, by far my largest one. This will tear a chunk of flesh out of you, so turn down the speed on your full-size router (the Bosch is the minimum I'd use) and take your time. Trim as much material with a jigsaw or bandsaw beforehand because this thing can grab. It leaves a pretty decent finish, but I do have fine lines corresponding to the separated blades, so just be aware that you'll need some finish sanding if you are doing fine woodworking. I bought this to rough trim stacked construction lumber and shop furniture, so its good enough for me.
Dennis Durec
Reviewed in the United States on April 10, 2024
first one I ever had cuts very good don't know for how long, but for now I love it
Logan strange
Reviewed in the United States on August 12, 2023
I was surprised at how smoothly this bit runs. I used it to flush cut an 1 1/2 thick counter top to a sink opening. The resulting cut was surprisingly smooth to the touch and didn't require much sanding to be finish ready. The tear out was very manageable and even avoidable if you just cut a little slower. Overall I'm very happy with this bit so far. Hopefully it keeps a sharp edge for a couple years.
C Budde
Reviewed in the United States on December 6, 2023
I used this bit to clean up a section of board I wanted to joint to another. The face of the board was so clean I didn't need to sand it or run a hand plane over it. I've only used the bit for maybe 4' of 1 1 /2" hardwood, so I can't speak to it's durability. However the initial use was great.
molly
Reviewed in the United States on November 17, 2023
I was trying multiple bit designs to shape 1” cedar boards using a pattern and this is the ONLY one that not only did the job well but also NEVER kicked back
Michael Arki
Reviewed in the United States on December 29, 2022
Was a little intimidated by it at first. But this router bit is amazing. Very easy to use and got excellent results. I turned the rpm down on my router and it was very smooth and i became comfortable with it almost instantly. I got better results with this bit than i did with my $250 bit from another “bits” company.Another advantage is the height of this blade lets me double up my stack and do two pieces at the same time. Again, be safe with it and you’ll get great results. It did amazing with both long grain and the end grain.
Gary
Reviewed in Canada on December 16, 2022
I used this bit on quite a bit of Sapele with no tear out, even against the grain. Some minor ridging was noticeable on the cut caused by the cutters not being perfectly machined to the same diameter. This was not much of an issue as it only took some light sanding to remove it. Cutter stayed sharp.
Mr Champ
Reviewed in the United States on April 21, 2022
The media could not be loaded.
Recommended Products
$26.96
$ 11 .99 $11.99
$54.66
$ 29 .99 $29.99