Your cart is empty.
Your cart is empty.Product Description
Hex Shank Flaring Drill Bit Set
Designed to work with 3-jaw power drills or screwdrivers, with a minimum of 1,800 RPM and 500 watts, for corded drills, or superior and 1,800RPM and 18V, or superior, for cordless drills.
Finish the Flaring in Seconds
Fasten the flaring drill bit into the drill chuck. Ensure it’s on tight. Firmly hold the tube at all times. Use your other hand if needed. Important: Use rotary mode only. Hammer/impact mode will damage the tube.
Please keep the drill at maximum speed at all times. Align the tube and drill. Insert the flaring drill bit. Maintain constant pressure throughout the process until the tool stopper has met with the tube.
Pull out the flaring drill bit from the tube. NOTICE: The flaring process is an “in-and-out” sequel that is approximately 5 to 7 seconds.
Wide Range of Uses
Home Air Conditioner Repair
Home Refrigerator Repair
Refrigeration Equipment Manufacturing
Refrigeration Equipment Repair
Jon B
Reviewed in the United States on March 3, 2025
As described. Appears to be good quality so far, easy to use
RVice
Reviewed in the United States on February 22, 2025
It's nice having one tool to swage pipe. If you're just getting started, go slow and put a piece of tape on where to stop if you're doing all the same size tubing.
Adrian
Reviewed in the United States on February 19, 2025
They work alright not bad for a fast flare
David H.
Reviewed in the United States on January 5, 2025
I needed these 20 years ago they flare a copper perfectly from your drill. Sure beats the heck out of a old flare and block. Don’t hesitate to buy.
Shane Underwood
Reviewed in the United States on July 30, 2024
These do not make a reliable flare. The flare is too small and the angle is no where near what it should be. If the tubing is not completely straight, it will deform the tubing.
Customer
Reviewed in the United States on December 28, 2024
They work just seem to have cheap coating on them.
Josh Gougeon
Reviewed in the United States on November 28, 2024
For the money it really doesn’t get any better. My father purchased another kind of flaring tool and had to return it due to poor quality, that is not the case here. These are great. I had a set when I was a technician in the field and needed these in order to install some mini split systems and could not be more happy with this set. Very easy to use and built well. I don’t think you can get such a good product for the money.
D. Allen
Reviewed in the United States on November 2, 2024
I tried one of the clamp style flaring tools but it didn't work well on the smaller copper tubes. These worked very well on my A/C install, particularly the 1/4" one. TIP: get some scrap and practice about 6 to 10 times. This not only burns off the power coating and polishes up the bit giving you a better flare, it also means that by the time you do the flare that counts you have more experience.
Recommended Products