Your cart is empty.
Your cart is empty. Specifications:
Bore diameter: 0.625 inches (slightly smaller than a Dime
Fits:
Centrifugal Clutch 11 tooth, 5/8" bore, use 35# chain
Predator 2.8 HP 97cc engine, some older 3hp engines
Engines with 5/8 inch (0.625 inch) output shaft with standard keyway
Set Screws NOT Included. Mounts onto crankshaft using bolt and washer on the end of the crankshaft.
Michael Weidenburner
Reviewed in the United States on August 5, 2024
Improvement from stock
John
Reviewed in the United States on November 2, 2024
It worked but nothing crazy.
Customer
Reviewed in the United States on April 21, 2024
Easy installation works great
Angela
Reviewed in the United States on April 21, 2024
Bought to fix our grand DAUGHTERS dirt bike & it was such an easy fix she on happy DIRT NOW YEA
Dohn Joe
Reviewed in the United States on June 5, 2023
Replaced the oem monster moto 80 with this a few months ago and it works great.
corey burrows
Reviewed in Canada on May 4, 2022
Had good luck with 3/4 shaft clutches but this 5/8 one is a problem. I think the spring holding the shoes in is weak or poor quality.
Tim C.
Reviewed in the United States on July 26, 2021
Was a good price for the clutch I ordered. I came very fast and is good quality!!
Wyatt
Reviewed in the United States on February 22, 2021
I have a 212, it is jetted, has a staged header exhaust, 308 cam, 8 degree timing advance, no governor, billet flywheel, 22lb valve springs, chromoly rods, and .009 head gasket. also has Pulstar spark plug and high drag magneeto. Far from stock. This clutch stood up to about 40-50 hours of punishment before the metal housing cracked. I have bought 2 other clutches of different brands since then and one of them also cracked in the same spot and the other is awaiting the same fate. It seems that regardless of brand, this is a bad design. I have a buddy that has a similar setup and a clutch which only has 2 shoes instead of 3 and he hasnt had the same issue. His is about to go out from worn shoes, not structural failure. I would recommend that if you have aftermarket parts. They sell them on BMI karts for 60-100.These make your motor die when they go out, youll know. The cluch completely seizes. The triangular shape on the back kind of loses a fin.With his the clutch has started to lag and make noises. It has seen about 130-150 hours.
jason
Reviewed in the United States on April 25, 2021
So far so good easy install took about twenty minutes and everything works as described
Recommended Products
