Your cart is empty.
Your cart is empty.Product Description
FireFiend
Reviewed in the United States on September 9, 2024
pretty bad quality and fit, but it does fit in my 2012 Altima RS.Came in warped because the product was bent into a box half its size
G. A Babington
Reviewed in the United States on July 27, 2024
Fits perfectly, splash guard underneath the radiator
Josh
Reviewed in the United States on May 17, 2024
I actually went to a used Pull-A-Part. This replacement was less expensive brand new, then pulling this piece from a used vehicle. I am more than pleased with the value I received. A small investment is protecting critical parts of my vehicle that can save on future repairs and extend the life of my car.
John Tate
Reviewed in the United States on February 3, 2024
The unit is easy to install ... even as a DIY'er like me.However, in general, the holes don't line up exactly as they should. I took what remained of my original Nissan part and laid it over top of this replacement and then modified the holes to line up, a little better. That certainly helped with the install. I'd still recommend this product for anyone though.
Alberto alvarez
Reviewed in the United States on September 10, 2023
Me agrado mucho a mi Nissan Altima 2011 le quedó perfecto asi no se moja el motor
Quasar209
Reviewed in the United States on July 25, 2023
This arrived 2 days ahead of when promised, and it fit perfectly. It's good quality for it's purpose. I highly recommend getting the clips listed below. 5 threaded retainer clips slip over the front edge so you can bolt it down tight along the front and then use Push Rivet Clips (like the ones you'll take out) for the left and right front and back edges and and two across the back. Piece of cake.--GOOACC GRC-70 35PCS Engine Under Cover Splash Shield Guard Body Bolts Bumper Fender Liner Push Retainer Fastener Rivet Clips
Joe T
Reviewed in the United States on March 9, 2021
Fit like it suppose to, but holes did not line up with bumper perfectly. Made it work
Mike W
Reviewed in the United States on October 21, 2018
As another reviewer noted, if you start on one end and work your way to the other end, the last hole will not line up. It took a little adjusting to make it fit. I also upgraded from push clips to U-style clip on nuts and bolts to make sure it stays put, which is also how I was able to enlarge the misaligned hole and still secure it well enough so it will stay on. It also helps I have a lift in my shop, because if I were trying to make this work on my back in my driveway, I would have had a bit tougher time getting the shield installed.However, the material it is made from seems pretty tough. It is a bit more flexible than the factory shield I replaced. It arrived loosely rolled and packed into a standard type box, not a large flat box. An hour in the sun in the driveway and it flattened out and remained flat.
Recommended Products