Your cart is empty.
Your cart is empty.This parking brake cable has been engineered and tested to match the fit, function and performance of the original brake cable on specific vehicles. It features a corrosion-resistant design and durable materials for added strength and longevity. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Toyota Tacoma: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013]
bruce
Reviewed in Canada on March 5, 2024
Good product
Customer
Reviewed in Canada on October 31, 2024
tres bien
Javier
Reviewed in Mexico on April 22, 2024
Excelente
Alisha macdonald
Reviewed in Canada on May 6, 2020
Said it was made for my truck it wasn’t!! It was way too short!! Returned ok but I don’t trust products like these off line now!!
FRANCOIS LARIVIERE
Reviewed in Canada on December 3, 2020
Piece identique, pour moins cher!
Brower
Reviewed in the United States on August 19, 2019
fits 2011 tacoma 4wd access cab
Ted
Reviewed in the United States on June 23, 2019
This is a review for both the left and right parking brake cables for a 2008 Tacoma. The length was correct but overall the quality of manufacture was lower than the OEM ones I took off. The clamp points are rubber "sliders" as opposed to the fixed metal ones on the original equipment. On the passenger side, the heat shield is minimal in comparison to the original equipment. Both of those things are minimal compared to the fitment of the cables into the tunnel under the cup holder. The Toyota version has a rubber boot that is several inches long, which gives the installer some ability to seat it correctly from the elements. This dorman one has a boot that is maybe an inch long and was difficult to work with. I finally gave up. My truck is 11 years old, so I'm not too worrried about it rusting out. But if I had to do it all over again, I would buy the OEM parts.
Amy
Reviewed in the United States on March 16, 2019
Works great
hogges
Reviewed in the United States on October 8, 2019
Doesn’t fit Toyota Tacoma 2nd generation, contrary to what is stated even on the Dorman website. The length is correct and so are both cable ends but this is where the similarities end. In the OEM cable there are metal protectors for each hanger, whereas Dorman has rubber bushings which are not only too small but they got both the number and the placement of them wrong. The rubber grommet towards the interior also doesn’t fit.Ended up getting a Raybestos brand replacement instead which looked and worked exactly like the OEM cable.
Recommended Products
