Your cart is empty.
Your cart is empty.Cortina 03-760BLK - 40 inch black polyethylene TrailBlazer vertical panel body only - no sheeting. Meets MUTCD standards. Stackable for easy storage.
Customer
Reviewed in the United States on October 23, 2024
Great product for what we needed. We removed in-ground handicapped signs and went with these for ease of mowing and plowing. At the end of our season, we're able to just store them away.
MCartier
Reviewed in the United States on December 1, 2023
Junk waste of money
Mason
Reviewed in the United States on November 3, 2022
You'll need a way to weigh down this product, because the lightest wind will knock it over. I just forced a traffic cone in the base and it held up just fine. Other than that it's a great product. I recommend this product if you can think of an easy way to weigh it down. Screwing it into a piece of plywood would work perfectly.
TGH
Reviewed in the United States on May 23, 2021
Works great. It’s light though. Semi strong wind will tip it over. Just put some rocks in the bottom and duck tape it (black to match)Love it!!!
E Art Thomas
Reviewed in the United States on September 19, 2020
They look great.. however if the ground is slightly not level they tip over. The slightest breeze they tip over.. bird lands on it they tip over. They probably work great in a place thats perfectly level.. maybe indoors.. I will be adding weight to the base
Joe
Reviewed in the United States on June 14, 2020
15lb base is the perfect amount of weight for the vertical panel if you want to easily move it around. Get the heavier weight if you plan to use the panel in a high wind location or if you want to make sure it is not easily moved by someone
TheEpicVoyage
Reviewed in the United States on April 11, 2020
Wind will take it but if u find a way to post it. It’s really good and catches attention. After three years this is the only sign that people followed
Mark A
Reviewed in the United States on July 11, 2019
Great graphics! You will need to anchor it down for any wind or disgruntled motorist! My sign set on top of gravel so I got a industrial stake from Home Depot and a black nylon cord. I pounded the stake in, drilled a small hole under the handle and threaded the cord from the top to the stake. Tied it to the stake (hammered in at an angle) and then placed it in position. When I pulled the cord tight and tied it to the handle I left enough cord on the end (about 6") to push it back in the hole I drilled. This just keeps someone from untie-ing and moving it or stealing it. They tried twice during the July 4th weekend and failed.
Recommended Products
$109.00
$ 52 .99 $52.99