Your cart is empty.
Your cart is empty.The WK paddle is suitable for diverse applications, this mixing paddle is notable for very good conveyance of the material. Two mixing helices for easy guidance in the material and minimal stress on the machine. Ideal for masonry cement, joint cement, stucco, grout and epoxy resin grout
Schursch
Reviewed in Germany on January 28, 2025
Perfekt
A. I.
Reviewed in Germany on January 16, 2025
Klasse Quirl, man braucht allerdings für Standardrührgeräte einen Adapter - die Ausgleichsfläche ist glatt wie ein Kinderar***
Jürgen
Reviewed in Germany on September 5, 2024
Ist sein Geld wert
J
Reviewed in the United States on February 25, 2024
Mixes as advertised, videos showing how it mixes help.
MayBen
Reviewed in the United States on August 8, 2022
Best Mixing paddle I ever bought!
tom mcdonnell
Reviewed in the United States on May 9, 2022
Commercial quality great for grout or mortar
Steven M
Reviewed in the United States on May 6, 2021
First, as the description says, it does not fit in a half inch chuck drill. If you have a cheap 6" bench grinder this is easily remedied in about 5 minutes. I just rotated the shaft in my hand while using the coarse wheel and then finished off the job with the fine wheel. Since end of the shaft has six sides which are close to 1/2" it is easy to see whether your grinding is even as the points are ground off. When the points are gone you have a perfect circle of the right size. Before I touched things up with the fine wheel there was a slight wobble when run in my drill.I suppose that if you poured an entire 80 pound big of concrete in your bucket and then your water this thing might give a lesser powered drill some difficulty. I start by putting some water in the bucket and then adding the mix and then more water and more mix. This works very well, and this mixer is much easier on the bucket than the large diameter paddle that I was using previously.I am using a Ryobi One Brushless 1/2" drill with a 9aH 18v battery. It has plenty of power the way that I have been using it and has not been overheating. I have several mixing paddles, each of a different style, this one is the best in my opinion.
Honest Abe
Reviewed in the United States on February 13, 2021
Very heavy duty and worth the extra cost compared to cheaper made mixers. Mixes brick mortar in a five gallon bucket for repairs easily.
david khan
Reviewed in the United States on April 11, 2021
Official Collomix product. I had absolutely no issues using the paddle in the Collomix mixer and it does a great job. It also cleans easily in a bucket of water needing only a wipe down and a small brush for the nooks and crannies of the welds. The finish holds up very well so far, too. The price cannot be beat as opposed to buying retail.
Roland dumouchel
Reviewed in Canada on January 17, 2020
Produit impeccable
Bob
Reviewed in the United States on November 9, 2017
constructed well and very sturdy. I have been using it to mix concrete. Used it with my 1/2 drill, as I could not find a quality, affordable 1/2 paddle. If you go this route, you will need to sand/file down the end to get it down to 1/2 inch. Took me about 30 minutes with a hand sander.
Hans Thorkelson
Reviewed in the United States on October 4, 2016
Well built, great for thick mortars. Wont entrain air or scrape plastic bits into the mix from the side of a plastic pail. Use a heavy duty drill with this if using for mortars, it requires a lot of torque to spin, if you have it then it performs. Only reason for four stars is that it is painted, so that will scrape off into the mix the first few times, but for the price what do you expect? You will spend a lot more for stainless, so for most users this is a great value.
Customer
Reviewed in the United Kingdom on April 4, 2016
AAA+
Recommended Products
