Your cart is empty.
Your cart is empty.Closed Cell Polyethylene 3 piece foam set to be used with Pelican 1750 case. Perfect for customizing your own rifle (or equipment) case at minimum cost. This is a perfect upgrade to Pelican's Standard Flat Foam and will last many more years that pick and pluck or other foams. Trace out your parts on the foam & and cut it yourself for the perfect personalized custom foam insert! Protect your investment, buy Case Club!
Dennis
Reviewed in the United States on July 14, 2024
I like the close cell for the top layer that you cut out for your weapon
Anna
Reviewed in the United States on May 18, 2024
Much better than what came in my 1750 case.
Razor Blade
Reviewed in the United States on December 13, 2024
Sturdy quality foam
Lorenzo Hernandez
Reviewed in the United States on November 8, 2024
It works beautifully.
Carlos Rivera
Reviewed in the United States on November 1, 2024
Safer phone
Cuaj
Reviewed in the United States on January 25, 2023
Fits inside my Apache 9800 case just fine. Wasn't the soft foam I was expecting to find in most other cases, but it should cut easily.
Hardriver
Reviewed in the United States on November 1, 2020
Love the closed cell foam. Easy to cut, looks great, and *much more* supportive than the usual convoluted (egg crate) foam most gun cases have. Yes it is expensive. But hey if you have a $2,000 rifle with a $2,000 scope, keep it secure in a nice case. This will make your $50 case look like a $500 case.
Nav
Reviewed in the United States on January 11, 2019
Received 3 pieces of foam as advertised for the Pelican 1750... although one piece (for the lid) did not appear to be closed cell. It seemed to be a standard open cell egg crate foam, which is ok, except it is about 1/2” too big. Thus once Inserted, it significantly bows out.The bottom 2 pieces are a 2.125” (middle piece) and a 1.125” bottom flat pad. The middle layer was about 1” off on the length leaving a 1/2” gap on each side. This was very disappointing.In general, the foam sizing is why I gave the product 3 stars. Every 1750 case is a standard size (even checked the foam in another 1750), so being off by 1/2+” is not acceptable... Maybe I got a bad batch.Personally, I also did not like the middle piece being 2.125” thick. Most of my items fall too deep into the foam once you’ve cut their slot. They are harder to get out given the closed cell foam firmness. Also, this means you cannot be as versatile with the bottom piece since it is so thin. If you cut that layer for use, most of my items would protrude above the foam, and then have direct contact with the layer above. I much prefer a 1.5” middle & lower layer or whatever comes standard with The case, but the ideal would be that it was Closed Cell. I can’t fault Case Club for this as their measurements were provided in the review... this was just my own lesson learned. YMMV
Recommended Products
