Your cart is empty.
Your cart is empty.
Advantage:
Made of Premium Quality Material.
Tested & Certified to Meet or Exceed OEM Quality Standards.
Compatibility with:
Chevy
Cheyenne 2014-2015
Silverado 1500 2014-2015
Silverado 2500 2015
Silverado 2500 HD 2015
Silverado 3500 2015
Silverado 3500 HD
GMC
Sierra 1500 2014-2015
Sierra 2500 HD 2015
Sierra 3500 HD 2015
Replaces Number:
22803702,23306741,590082,PAC13.
Includes:
1Pcs Rear View Backup Camera.
G
Reviewed in the United States on March 19, 2025
Did not use it. I returned as I didn’t need it.
dont buy cheap
Reviewed in the United States on February 8, 2025
Camera quality is awful and half of the grid lines are missing
gervais parent
Reviewed in Canada on February 27, 2025
works awsome easy instal
Dennis D.
Reviewed in the United States on February 19, 2025
Easy to install and works great. Replaced the scratched and hazy camera that was on my truck. It's nice to have a clear image while backing up again.
Michael
Reviewed in the United States on January 14, 2025
2015 Silverado 2500HD- Easy install, 15 minutes. You will need a T15 bit, a T20 bit, and 3’ of string to chase the wire. The unit plugs in next to the spare tire. You will not need to remove the spare tire to access the plug. I was hoping for as clear of a picture as my wife’s 2021, I did not get that but I did get a much, MUCH better picture than what the stock camera offered. Pics attached. Happy with the purchase.
Bill
Reviewed in the United States on September 17, 2024
wasn't hard to change, the two difficult things were fishing the wire and removing the old plug on the truck side. I wound up destroying it to get it out but if you take your time you can do that without damaging the truck side of the plugNot as clear as my 2023 but still a major improvement
Mark B.
Reviewed in the United States on August 7, 2024
Great replacement for blurry camera. Easy installation. Put down tailgate, remove panel on backside of tailgate, two screws hold the camera in. Cut the wire on old camera and tape new wire to old one to use old to pull new through holes. Go under truck to pull old and new wire through the holes. Route under bed, disconnect old one and connect new one. Didn’t have to mess with spare tire at all.
Kelly Azarowski
Reviewed in the United States on August 29, 2024
Used it to travel thru a few states cross counrty
David Hart
Reviewed in the United States on May 13, 2024
The first one I received was defected, would not work at all. I’ve received a replacement. I found it to be OK but not great. Image was barely as good as original or Slightly less. Viewing area was smaller than original factory cam. Would not recommend as upgrade. Maybe OK to replace broken or bad existing, But still has a smaller image.
Brian Wilcox
Reviewed in Canada on December 6, 2024
A few installation tips: Remove the spare first, much more room. Unplug the old camera. The wire is the braided one just to the drivers side of center near the backside of where the spare was (near the inside of the hitch). Pull down the red tab and pull out the plug. After unscrewing the old camera, cut the wire off and tie it to the new plug then grip the old wire between the tailgate and the bed and pull the plug out of the TG hole. Untie the wire and feed the plug down through the bed hole. When under the truck, gently pull the old wire out of the zip ties (cut the old ties if needed).
Bill Rennick
Reviewed in Canada on December 17, 2024
Replacement for pickup tailgate
jeffrey payeur de taxe belanger
Reviewed in Canada on December 13, 2024
Peut être suis-je trop naïf pour vérifier avant de tout défaire mon panneau et de passer l'après midi a joué dans la slush et dans l'anti rouille mais j'ai eu une agréable surprise lorsque j'ai remarqué que la plug n'étais pas la bonne . Ça m'apprendra à faire confiance au produit cheap
Lou I
Reviewed in Canada on November 10, 2024
My backup camera was very cloudy, seems to be a common issue. Fitted this in about 15minutes, very easy to install. Picture is crystal clear again.
Recommended Products
