Your cart is empty.
Your cart is empty. Description:
Very powerful Digital Satellite Signal Meter Finder which is able to find satellites in a very quick way about within 15 minutes if no accident. It is very lightweighted and compact,very convenient to use.Anti-corrosion connectors also make sure long time use and it is very worthy of trying.
Specification:
Input Frequency: 950-2150 MHz
Input Level Min: -40dBm
Input Level Max: -10dBm
Input Impedance: 75Ω, F connector
Output Impedance: 75Ω, F connector
Power Supply: DC 13/18 V
Operating Range (LNB gain): 52-60dB
Package Included:
1* Instructions
1* Digital Satellite Signal Meter Finder
1* Compass for free
Q &A:
1. how to install the satelite finder and detect the signal?
a. Connect a jump cable from LNB to the satellite finder's "Satellite" port. Connect the "Receiver" port, a DC 1318V power which comes from the satellite receiver
b. Make sure that the satellite finder is properly connected. Plug in the AC cord and turn on the satellite receiver
c. Set the dB to be 1 or 2 by ATT button, the signal LED will show from 15 to 30, then you can adjust the dish postition, when you hear the buzzer alert and the value of signal strength getting more and more, it means you get the statellite signal
d. Set the dB to be 3 or 4, adjust the dish again and again until the value of the signal strength is maximum. Then you can see the LOCK light in the satellite receiver, if the lock light is lighting it shows you find the desired satellite. Otherwise you need to adjust the dish again
Customer
Reviewed in the United States on February 27, 2024
The instructions are clear, and it sort of works, but don't expect any accuracy from this, it's more luck than science.
Lance McKinnon
Reviewed in the United States on November 27, 2024
This is a time saver by finding your satellites. Connect and go.
Roger Tipsword
Reviewed in the United States on November 16, 2024
Help setting up system.
Tony D
Reviewed in the United States on January 25, 2018
Works great. When using must move dish very slow up or down / left or right to get the strongest signal. Once your locked in and have the dish secure remove the finder and reconnect the cables and check the tv. Tv will not work with finder connected.
Carl Simerson
Reviewed in the United States on May 12, 2017
I bought this item to assist in setting my dish antenna as we move to different locations about every 30 days do to work. It worked the 1st month, January. It didn't work the next month, but I was able to get s signal by guessing. The third move or March's move couldn't use it as we were parked in the middle of a live oak forest and never find a signal. Tried again in both April and May, no results. Appears to be burned out, lights up but sound or signal. I guess it was waste of money. The 30 day warranty is a joke if you only use once per month.
burr1710
Reviewed in the United States on December 30, 2015
After Upgrading my Dish from a SD def to HD def quality (3-LNB) i tried to aim the dish by eyeballing it and a compass. However this failed after a day of trying. So I ordered this item. It did NOT get me right on alignment but it got me close enough to where I could fine tune it. Both of my SAT tuners on the DVR are receiving roughly a 97% signal. My area also had 8 inches of rain in the last 3 days. Only lost the sat signal a few times in and out occassionally for a few hours. But that is normal. Overall this item should help you get close to the right spot in alignment and it is worth the 11 dollars. Side NOTE: When installing and searching for the Satellite dish in the sky you will need to remove this digital finder once the ALT is lowered and more accurate. This will allow the DVR to acquire signal and show the true % of signal being acquire. At least in my situation this was the case. With this piece still in line between the dish and receiver i was unable to complete sat setup and DVR settings.
RegularTrade
Reviewed in the United States on December 21, 2015
It works OK....but I wish I would have bought an analog one.1. The compass doesn't work at all. I can make north face any direction I want to because it really doesn't rotate.2. The beeping is great and give you a general idea of what's going on without looking at the meter.3. Even after adjusting the meter, it seems as though the Guage is all or nothing. It'll jump for 67% to 99% but not go anywhere in between. It'll be begged at 99% during 5° of rotational adjustment. I ended up just finding the low end and high end where the beeing completely stopped and then adjusting so I was in the middle of the two. This is why I think the analog Guage may be more accurate in fine tuning.
Recommended Products
