Shopping Cart

Your cart is empty.

Your cart is empty.

6 AN Male Flare Fuel Cell Roll Over Valve Aluminum AN6 Rollover Valve Tank Mounted Fitting Adapter Black and Blue Anodized

Free shipping on orders over $29.99

$15.88

$ 6 .99 $6.99

In Stock

About this item

  • Thread Size: Male JIC -6 AN 9/16 x 18, Mounting hole size is 14mm, Surface treatment: Black Anodized Finish for Durability
  • Made of High Performance Lightweight 6061-T6 Aluminum Material
  • It is an excellent safety device that can be installed in any fuel cell or tank.
  • Serving as a non-restrictive vent, this tip over /rollover valve check ball closes on a rollover to prevent fuel from escaping
  • Access to the inside of the tank is required for installation



This product provides free ventilation until the fuel tank / cell becomes inclined to an angle of more than 90 degrees. In this situation a stainless steel ball (acting under gravitational forces) seals the vent shut preventing fuel from escaping through the ventilation system. This valve has been designed to mount onto the top of the fuel tank / cell. In the case of fuel cells with a top plate, the valve can simply be added to the plate.
Fuel Tank Vent Valves allows the fuel tank to maintain a constant and safe status by minimising build up of pressure and allowing the tank to vent should a vacuum be experienced
When installed the valves are open to atmosphere so vapour can collect inside the vehicle. All installation should be piped to the outside of the vehicle or connected to a charcoal canister. For tarmac vehicles run the pipe to the top of the body and then down to a point just below the base of the tank. The valves should be positioned as close as possible to the rear of the tank so that under braking the fuel load will move towards the front of the tank and away from the valve.
Access to the inside of the tank is required for installation
The mounting hole size is 14mm
Also comes in different sizes, pls contact us for more product information.


Joe Foster
Reviewed in Canada on September 2, 2024
Very good quality
Rube
Reviewed in the United States on May 13, 2024
Part is 👍
Mathieu
Reviewed in Canada on August 2, 2023
Arriver rapidement reste a tester.
Tony
Reviewed in the United States on August 15, 2021
This vent valve seems to work good very happy with this product
Daegan Eubanks
Reviewed in the United States on July 13, 2020
Good buy
Landon Lee
Reviewed in the United States on June 4, 2020
nice vent, easy to install with the AN fitting.
OMGSS
Reviewed in the United States on December 19, 2020
High quality
Robert Montgomery
Reviewed in the United States on February 23, 2019
Easy to install, drill a hole and thread it together. Comes with sealing washers. Seems to work well. I will update my review with more information about functionality after I roll my truck.