Your cart is empty.
Your cart is empty.Product Description
Special suggestion:As long as it is the joint between metal and metal, screw glue is applied to any part to make the product more stable.
heathersman1983
Reviewed in the United States on March 11, 2025
Didn’t last even 1 battery cycle…. Sheared the roll pin on input shaft with stock system in Traxxas Stampede!!
Dustan M.
Reviewed in the United States on February 19, 2025
Very nice could use a hardened roll pin tho. Same issue that I had with factory trans on my rustler after years. Running castle sidewinder sct esc and motor same one for about 7 or 8 years and it ate the factory trans roll pin be ready if you have a monster unit in one of these cars or pull just have to change that pin from time to time. I ran it hard and it held up good till it didnt. Definitely buy again
Josh Reames
Reviewed in the United States on September 29, 2024
it seams to be doin a good job
Fred van
Reviewed in the United States on July 18, 2024
The media could not be loaded.
Ari
Reviewed in the United States on June 17, 2024
Gone through a couple spur gears so having the whole kit to fix stuff as it goes is very handy. Rebuilt the whole gear box into a metal gear casing recently and everything fit's perfectly.The blue-grey piece is actually a slipper delete in case you don't want the slipper clutch or didn't know what it is like me at first!
Jason Bouslaugh
Reviewed in the United States on May 12, 2024
Direct fit
Recommended Products