Your cart is empty.
Your cart is empty.Samantha
Reviewed in the United States on March 24, 2025
This trim transition was exactly what I needed! The quality is great, and it was super easy to custom cut with a razor for a precise fit. It sits perfectly in place and gives a clean, seamless look. So satisfying to install, highly recommend!
Jessica
Reviewed in the United States on February 23, 2025
The tile from my bathroom to the vinyl of my living room has a sizable height difference, and this was the easiest solution and it looks great! The color of the fake wood on the strip is darker and more red than the paler, yellower vinyl wood flooring, but I don't mind at all.
Mike Johnson
Reviewed in the United States on January 16, 2025
Product was very easy to cut using my utility knife and easy to install. Been a few weeks and holding strong. Definitely recommend for a nice look and DIY project.
Jenny
Reviewed in the United States on September 21, 2024
Easy to cut and sticks well where there is adhesive. I wish there was adhesive on both the upper and lower portion on the bottom since the adhesive is only on the lower part that angles downwards but it worked better after adding some additional glue
Rrusty
Reviewed in the United States on November 20, 2024
I got this hoping to replace the “T” transition that broke off of my floor transition. I had hoped that it would cover the broken piece. It does not cover it. Also, my wood is freshly waxed, and the adhesive does not stick well to it. Both of these issues I am having cannot be blamed on the manufacturer; therefore, I am basing my review on the appearance of the strip and ease of use. The rubber is easy to cut with household shears and has a lovely wood grain. The grey has some variation of different gray and will therefore match many gray tone floors. The backing is removed easily, and installation is a snap. There are no instructions and no “floor prep” wipes. I suggest finding something to remove any coating or dirt from the floor before you try to stick to the floor. I will purchase it again when I have better prepped my floor.I did not take any pictures, but the listing pictures are a very good representation of the item itself!
Steve
Reviewed in the United States on October 7, 2024
This works really well for the ridge/edge that i have on my floor transition. Wasn't expecting much, but it indeed makes stepping on the threshold between my hallway and living room more comfortable and allows my robot vacuum to navigate better over it as well. Not a perfect match color wise but it does the job pretty well and is also pretty cost effective.
Cocoababy
Reviewed in the United States on October 18, 2024
I had a small closet floor DIY project that required a transition strip to prevent a gap between the laminate and tile. This strip was the closest color match. It is a soft almost silicone feeling material that’s very flexible and came rolled. Since it was rolled, getting it to lay flat was a challenge.The tape was very sticky but due to the unevenness of the floor it was difficult to get it where it needed to go. I ended up using another piece of laminate to even it out and using gorilla glue and painters tape in order to get it to stay down.I had a considerable gap of about 1.5 inches between the floor types which is too wide but that’s just how the laminate ended up lining up. If this were the typical 5/8’ gap required between floor types then you should be ok and not have to use glue. You will, however, still need to tape it down since it comes rolled and you’ll need it to lie flat. I used painters tape so it wouldn’t leave a sticky residue and left it there 48 hrs before removing the tape. The transition strip looks perfect now and I haven’t had any issues with it rolling back up. I’d recommend this product for small projects like this or interior transitions.
draagonfly
Reviewed in the United States on October 1, 2024
I thought this ramp was going to be hard rubber, but it arrived curled in a circle, which made it super difficult to use. It still hasn't even uncurled after three days. The adhesive backing had a cover over it that you peel off, like most do, but because of having it rolled up, the cover allowed dust and debris to get in there, making it less effective to hold the ramp down. I thought this would be tall enough to bridge the gap from my front patio into the house, but it definitely was not. It fit better on the inside of the door leading to outside. That part worked for sure, but it was too long and needed to be trimmed down by about six inches to fit. Trimming it was annoying because even with a sharp box cutter, it was difficult so now we have a good edge and a jagged edge and of course the ugly edge is the part. you see. For interior doors I can see how this would help get any wheel - moving dolly or wheelchair or other - over the hump of the threadhold, but you don't need these as much inside as to fill that height gap to outside. If that's what you're looking to do, this won't be what you're looking for.
Recommended Products