Your cart is empty.
Your cart is empty. Type
4 Flute End Mill Bit
Dimension
Cutting Diameter : 0.47"/12mm
Shank Diameter: 0.47"/12mm
Cutting Depth:26mm/1"
Total Length:83mm/3.3"
Package Content
1pcs x End Mill Bit
Please Note
1.Stop immediately in the processing of anomalies when using the end mill bits and find out the reason before processing.
2.Pay attention to the condition of wear and tear of the cutting edge and timely repair the end mill bits.
3.Cleaning the end mill bits and use oil after using, keep end mill bits properly.
Customer
Reviewed in the United States on February 13, 2024
I purchased for 1 part counterboring 2 holes .660” deep on side of shaft. Bores were precut at 3/8” dia and it still failed. Dull before halfway done with second hole really before starting but this is when it was past usable. If I had to do it over I would spend extra on something else. My expectations were low and it still came up short.
Recommended Products
