Your cart is empty.
Your cart is empty. Supply voltage: DC 5V
Trigger mode: High / low level trigger
Normally open interfaces Maximum load: AC 250V/10A, DC 30V/10A
Trigger current 5mA
The power indicator (green); the relay status indicator (red)
Module Interface:
DC + : Power supply positive (module supply voltage must be DC, and the voltage to be consistent with the relay voltage.)
DC - : Power supply negative
IN1-IN8 : According to the setting of each way, it can control the corresponding relay to be high or low.
Relay output:
All interfaces can be directly connected,user-friendly
NO1 - NO8: relay normally open interface
COM1 - COM8: relay common interface
NC1 - NC8: normally closed relay interface
High / low trigger select :
S1-S8 is the relay 1-channel to 8-channel high / low trigger selection
COM and Low connected, the relay is low-level trigger
COM and High connected. the relay is high-level trigger
Pacakage included:
2 x 8 channel relay module
OTINEB
Reviewed in Mexico on November 8, 2023
Unicamente hay que mover los jumper para funcionar con 5V
Demon916
Reviewed in the United States on July 10, 2022
I wouldn't use these for the rated 10amp of the relays.The circuit board is very thin it actually flexes due to how thin it is. The copper traces are barely .5 oz and would not support 10amps of anything. I do like the optional Hi (+5v) vs. Lo (Gnd) trigger jumpers, but would only use this for low amps like 1 maybe 2 amps.
Recommended Products
