Your cart is empty.
Your cart is empty.
Eyech 2Pcs 2.35 mm Keyless Drill Chuck Collet Conversion Adapter
Specifications:
Material: Aluminium alloy
Size: approx. 5*1.5*1.5cm/1.96*0.59*0.59''
Net weight: approx. 11g
Clamping range: 0.3-3.4MM
Handle length: 2.35mm
How to use : First governor speed adjustment in the "minimum or zero turn", then turn on the power, adjust the speed, speed not more than 1w, to avoid damage to the shaft.
Caution : Once installed on this universal chuck. Please do not direct adjusted to high-speed operation, or may cause the rear axle bend.
The package include:
2pc×2.35mm Keyless Drill Chucks
Sloane Schrodinger
Reviewed in the United States on September 27, 2024
Bummer I wanted to like these. Unfortunately all three vibrate badly at speed in my nail drill. I chucked them up in my regular Makita drill so I could turn them very slowly. I put a 2 inch long straight rod in the chuck and ran the drill. All three have bad run-out that is easily seen on the drill. The little chucks work fine for clamping down but the run-out is unacceptable. I haven't been able to figure out how to fix it. The shaft attachment to the chuck is not concentric nor perpendicular. I could bend the connection (maybe) to fix the perpendicularity but I can't figure out what to do with the off center issue.
J Perkins
Reviewed in the United States on September 10, 2024
Returning these. They are bent slightly and wobble. If you don't mind this, then they'll work fine for you.
Keith Horeb
Reviewed in the United States on July 6, 2024
so I bought some fine water based sandpaper and put the piece in my cordless. Then sanded it until it would fit in my gf craft drill. She was so happy......just know you will need to shave these down......
la
Reviewed in the United States on May 9, 2024
Not high quality and I expect the runout would be unacceptable for any real machine work but for the price they have a place.
Clarence
Reviewed in the United States on May 10, 2024
Two size adapters. One will close almost completely so it will fit those micro drill bits. I don't use the other side because I don't need it. My micro drill will fit all other bits I need.
Customer
Reviewed in the United States on February 9, 2024
It's also great if you're going to be using smaller drill bits. I'm very happy with the durability and the ease of use.
R. Dijkman Dulkes
Reviewed in the United States on September 22, 2023
I bought these to fit drill bits in my Dspiae ES-P sanding pen, which takes 3mm shanks, but NOT 1/8” shanks. Dremel bits all have 1/8”, 3.175mm, shanks and they are just barely too big for the Dspiae ES-P.A 1mm drill bit runs without any wobble in the sanding pen. Perfectly straight.I believe that reviewers that complain that this Chuck is not centered all try and run it in a Dremel, as it would be off center in that tool. For a true 3mm tool this chuck is great.
Opinionater
Reviewed in the United States on March 30, 2022
Low cost and works great. Used for low intensity hobby work.
Recommended Products
$24.58
$ 12 .99 $12.99
$15.38
$ 6 .99 $6.99