Your cart is empty.
Your cart is empty. Package Included:
2 x 1-inch Scope Adapter Ring/mount
4 x Gasket
1 x Hex Wrenche
Customer
Reviewed in the United States on December 26, 2024
I needed a mount for my scope camera and was worried that I would have to mount it to the barrel. However, this mount fits both of my scopes without having to adjust their mounts. The camera fits perfectly on top.
neilz
Reviewed in the United States on January 30, 2024
MOUTED ON MY 12 GA MOSSBERG MAGAZINE TUBE USING INCLUDED SPACERS . IT'S VERY TIGHT , NO SLIP . GREAT FIT .
James Murray
Reviewed in the United States on January 11, 2024
Perfect fit for my Shotgun
RidgeRunner
Reviewed in the United States on September 21, 2023
This Picatinny rail adapter is 30mm with a 25.4mm plastic insert filler to fit most standard 1 inch or 30mm rifle scopes. I used one on a scope to allow me to mount a reflex sight above or sideways on the left side of the scope. I installed one on the front end of my 12-gauge pump shotgun tube magazine for mounting a green laser. My pump grip stops about 3 inches short of the barrel clamp so on my shotgun there was plenty of room though it would not easily provide mounting for a reflex sight as the configuration is not reasonable for that. I did need to remove and reinstall the barrel to get the strap between the barrel and the magazine tube. I just removed the threaded cap at the end of the magazine tube, slid the barrel off, attached the picatinny rail adaptor, and reinstalled the barrel. Took about 5 minutes with the only tool required being the hex wrench that came with the Picatinny rail adapter.Your magazine tube may be a different size. Mine is about 25.6mm and fit without modification of the plastic spacer. I will probably buy again.
Vin B
Reviewed in the United States on November 3, 2022
Purchased it for one of my relatives. According to them great value for money
Otis
Reviewed in the United States on June 5, 2021
Works great for adding a reflex sight to a scope. Size everything up and you shouldn't have a problem. Quick & cheap to do it yourself. Gives you more options of choosing what reflex sight you want.
Poppa T
Reviewed in the United States on November 1, 2021
I purchased this for so I could mount a light on my BIKE and the diameter was a tiny bit big. But 2 small strips of mounting tape on the inside diameter and it fit like a glove and NO SCRATCHS. AND I have an extra , just in case I get another ... bike
Eric
Reviewed in the United States on August 2, 2020
Bought these for my 10/22 takedown so I wouldn't have any problems keeping zero with my green dot. Had to do some custom fitting but they work great.
Recommended Products
