Your cart is empty.
Your cart is empty.Eric
Reviewed in Canada on January 14, 2025
It’s a professional quality kit. Take your time and do it properly.
Artie
Reviewed in the United States on September 26, 2024
You can't beat the PerfectIt line. Cuts through fine scratches like butter. Leaves a very professional finish.
Rocketeer
Reviewed in the United States on September 20, 2024
Used this product for years, always yields great results.
lora evans
Reviewed in the United States on July 10, 2024
Great quality. Great product. Would recommend.
William Imlay
Reviewed in the United States on June 6, 2024
The picture is worth 1000 words !!!!!!! Easy to use and great job . Looks better than new !!!!
Vitaliy B
Reviewed in the United States on May 23, 2024
Should last me a long time. One of the best compounds out there.
Troy Van
Reviewed in the United States on October 25, 2024
Used other products but if you want the best 3M works the best in my opinion.
Ken Palmer
Reviewed in the United States on October 23, 2024
Works great!!
Customer
Reviewed in Canada on September 16, 2023
Had lots of orange peel when I painted my car. Wet sanded it with 1500 grit sandpaper and then used the cutting compound and polish. Car turned out great, gotten lots of compliments.
Peter Wall
Reviewed in Canada on December 1, 2021
Very happy with the product
Bhuvan Kamboj
Reviewed in Canada on November 8, 2021
Flawless finish
Fernando
Reviewed in Canada on September 29, 2019
Is not the best one but is good
TC
Reviewed in the United States on May 11, 2019
I have to admit, it's the best stuff out there! I used to be in the boating business so my expectations are a bit higher than most and I've been in numerous boat factories before. I bought my low hour boat that was neglected. Graphics were torn up and gelcoat was very scuffed, light to medium oxidation, with hard water etching over most of the black gel coat. I wet sanded 1000-2000 the light to moderate scratches and filled in a thumbnail sized chip. The first step compound ate through the sandmarks, etching, and oxidation very quickly leaving a beautiful shine. Step 2 and 3 provided a mirrored like finish that was probably nicer than when the boat left the four winns factory 12 years ago. The exposed gelcoat and the gelcoat that was under the graphics are now indistinguishable. It literally looks like a mirror when you look directly into the black. In addition, I purchased the top grade Dewalt buffer and all three 3m pads, white black and blue. This is the professional setup as I wanted to do it right the first time around. I thought it was a very easy straightforward system to use. With a weekends worth of effort, I increased the value of my boat by several thousand dollars!
Recommended Products