Your cart is empty.
Your cart is empty.Product Description
Y&H 180W MPPT Solar Tie Micro Inverter PV Input DC16-26V AC110V/220V Output
Juan Villaseñor
Reviewed in Mexico on February 24, 2025
Funciona muy bien. Lo tengo trabajando un poco fresco a 300W mediante 2 paneles de 150W en horas pico puedo ver que entrega unos 260W genera poco calor con esta carga de trabajo. Cumple su trabajo eficientemente.
John Bengtson
Reviewed in the United States on February 15, 2025
Just like the first one I bought: a good price, and works fine.
James K.
Reviewed in the United States on September 6, 2024
For an invertor rated at 700 watts, even going to half that capacity makes it overheat too easily. It derates down to 250 watts often. If you're looking for consistency, probably don't panel over that wattage, or use it in colder climates only.
Natucha
Reviewed in the United States on August 18, 2024
The media could not be loaded.
hoang tran
Reviewed in the United States on July 10, 2024
I would give it a 5, if the MC4 connector is not hard mounted to the casing, making removal harder
LaserDispaly
Reviewed in the United States on June 18, 2024
I bought 2 of these. they both exhibit seeking sync but never sync with the grid (green light always flashing). Coupled with 12v 180w panels
P. Ng
Reviewed in the United States on October 20, 2024
My first one stopped working literally the first time I plugged it in. I set it up, turned it on, I then saw that it was generating power and after a few MINUTES, it stopped. It would no longer turn on.I contacted seller and got a replacement.The replacement failed after around 40 DAYS! I noticed it wasn't generating power one day so I turned off the AC and then back on and it started to work again. The next day, it no longer started up, no matter what I did.On a side note, when this thing was working, I measured temps around 140 F to 150 F. It gets hot and there is no built in fan so I wasn't surprised when it stopped working after 40 days.
rasa123
Reviewed in the United States on October 19, 2024
Keeping in mind how much this costs, it does the job. But be aware expect a max efficiency of about 42% (I should have known it would be 42%, it's always the answer). For example, I have 2 250W 33v panels hooked up in parallel and have seen a max out of 210W at the wall. I've tried actively cooling the inverter and leaving it passive, but haven't noticed a significant difference (because it does get hot).Also, I measured the power factor and I saw anywhere from 65 to 75, which isn't particularly great but within the range of what I expected for a product like this.
Recommended Products