Your cart is empty.
Your cart is empty.This is an O.E.M. Authorized part. Fits with various WHIRLPOOL brand models. Oem part # 660579.
Customer
Reviewed in the United States on January 20, 2024
Pretty much unscrew 4 screws and pull out the old, pull off connectors and then reverse the order. Should not take more than 5 min and that is taking into account sliding the over door off to make it easier. Quick way to save a couple hundred dollars for someone to come out.
Bookwrym
Reviewed in the United States on December 30, 2019
Fit and worked perfectly. Though I suspect not as hot as the original which took 40 years to burn out.
Daniel Baker
Reviewed in the United States on July 28, 2018
OK. It was a bit difficult to tell in advance that this was going to fit; no dimension of the spread between the prongs but it worked.
mike
Reviewed in the United States on December 31, 2018
Easy to install, only thing the ends where the clips go had to be bent out about a half inch on each side. Also the new bracket didn’t line up with the screw holes on top of oven. I just used the old one and it worked fine. Total time to remove old broiler coil and install new one was half hour. Repair guy wanted $160. So I saved a few bucks.
Customer
Reviewed in the United States on December 29, 2018
No complaints I would order again
Craig S. Jones
Reviewed in the United States on October 31, 2017
Not too terribly difficult to install. Do not forget to disconnect power source before servicing any appliance! Having a spare burner will save much grief. They burn out in the most inconvenient of times!
Alice McWade
Reviewed in the United States on August 13, 2016
worked perfectly I have a new oven
Recommended Products
