Your cart is empty.
Your cart is empty.George
Reviewed in the United States on July 4, 2024
This item works so good I buy it again in the future thank you for delivering safely the items
C. McG
Reviewed in the United States on March 11, 2024
I have a thread-together BB on an aluminum frame that installed without an issue. The cranks turn really smoothly. I bought one to install in a carbon shell but for whatever reason, I can't get them torque enough to where the safety pin on the NDS will engage. The spindle needs another mm or so through the shell before the NDS crank will lock in. I've torque within spec (40nm) but I'm not comfortable tightening any more than that.Even test fitted on the spindle though, it seems like one of the bearings isn't seating properly. It's difficult to get the spindle through without a mallet and the cranks barely turn more than 3/4 rotation once they're in. I'm returning and just going to install a Shimano BB. I wish this would have worked out since my other experience was good.
aldoWaldo
Reviewed in the United States on December 10, 2024
Good quality BB!
Yoshmann
Reviewed in the United States on May 30, 2023
This BB is great, so long as you keep it dry. I I'm on my third in 2 years because I submarined the first two on creek crossings. I saved the second one for a bit after removing the outside seal and blowing/drying the water out, but after that, the seal couldn't keep water out during routine bike washing.As far as noise, I'm a large rider, that does a lot of technical climbing, and have never had an issue with noise or creaking. From a technical standpoint, the BB is bomb proof.Just keep it away from water!
Thomas Morgan
Reviewed in the United States on December 12, 2022
See picture, broke in half. In theory this seems like a good idea, however Wheel Manufacuring execution is very poor. Their customer service is no better. Go watch some Hambini videos, it is not uncommon for quality control on some Asian made frame to be less than ideal. On the bottom bracket this means you may have angler or offset misalignment; this can lead to bottom bracket creaking. This product when working does help eliminate the creaking. However, the aluminum on the treaded side is so thin it can't stand up to the stresses caused by possible misalignment. If they were to increase the inner diameter on the threaded side, hence increasing the thickness of the aluminum it would probably be a great product, but as designed is just a waste of money. The Token Ninja is about half the price and has better reviews, I'm trying it next, hopping in works.
CO athlete
Reviewed in the United States on August 15, 2021
Super simple to install and this has been one of the best upgrades I’ve purchased for my bike. High quality BB and NO creaks from the bike any more.
Richard
Reviewed in the United States on April 20, 2020
After 2 years of hard riding my press fit bottom bracket had developed creaks and side to side movement. Installed this bracket and it is rock solid now. I've got about 100 miles of Pisgah trails on it so far and it is doing great. Highly Recommend the product!
ojdidit
Reviewed in the United States on October 7, 2019
My initial assessment of the BB is that it is really going to be nice and after only a few hundred miles I'll stick with that. I installed it on my Gravel bike, a Salsa Warbird. I like that it threads together for a press fit. This seems to me that the alignment will be kept and would be a little forgiving to a bottom bracket shell that may be a bit off in manufacturing. It does take its own tool. It is not compatible with Shimano as far at the tool goes.
Recommended Products
