Your cart is empty.
Your cart is empty.Product Description
Information
When tapping, appropriate lubricating oil is good for cutting or cooling, making the cutting easier and faster, improving the smoothness and dimensional accuracy, and helping to extend the service life.
The following lubricants are recommended: steel - cutting oil, machine oil; pig iron - dry oil; aluminum - kerosene; stainless steel - mixed kerosene; hard plastic - dry oil. Be sure to select the appropriate cutting oil for complex tapping process and apply anti-rust oil for maintenance after use.
Die Stock Handle Wrench
The die stock fits round dies. The die handle wrench can help to repair damaged bolts and threads or just remove bolts and threaded rod.
Easy To Use
The positioning groove of the die should be aligned with the fastening screw in the middle of the die wrench, and the screw should be inserted into the slot of the die and tightened.
Features
- Round die holder is featured with adjustable screws to fix the dies
- The die stock can securely hold round dies and is easy to operate.
- Provides good wear resistance for long service life.
Round Threading Dies
The round dies can process, correct or clean external threads. Conical locking hole, strong locking and not loose. Great for maintenance and repair work on pipes, boards and machinery.
Wide Applications
For rethreading existing threads in hard materials like metal, or making new threads in softer material such as plastic. Suitable for tapping stainless steel, aluminum alloy, cast iron, copper, iron, aluminum, plastic, etc.. NOT suitable for tile, concrete, walls, stone, etc.
Alloy Tool Steel Dies
- High hardness
- Wear resistance
- High hardening capacity
- Tempering resistance
Tips for Round Dies
The end of the bar should be chamfered 1*45 degree, and the chamfer is too large to cut in. The bar diameter should be smaller ( about 0.05mm-0.15mm) than the nominal diameter of the required thread. Excessive diameter can easily cause difficult cutting and lead to damage to the die teeth.
When tapping, add suitable lubricating oil to the cutting edge, and repeat the operation 3-4 times until the thread length is obtained. When using by hand, pay attention to even force and avoid blind force.
Chris
Reviewed in the United States on January 23, 2025
I had to put the die holder body in the lathe to turn a little out of the center - without doing this dies would not fit.
Mike M
Reviewed in the United States on June 8, 2024
I needed to cut about 3 inches of thread on 3/8 inch steel rod to make a modification to my bandsaw. This wrench and die combination worked well and without problems. I used plenty of oil and reversed every quarter turn to break chips. The threads were clean and easily threaded into the mating component on the saw. There appears to be plenty of life remaining in the die. This was a good value for my application.
Imbasman
Reviewed in the United States on September 18, 2023
Nuts don't tighten well on threads
JustMyOpinion
Reviewed in the United States on August 15, 2023
Does the job, not sure what else to say about a tool that works as designed.
Recommended Products