Your cart is empty.
Your cart is empty.Product Description
Information
When tapping, appropriate lubricating oil is good for cutting or cooling, making the cutting easier and faster, improving the smoothness and dimensional accuracy, and helping to extend the service life.
The following lubricants are recommended: steel - cutting oil, machine oil; pig iron - dry oil; aluminum - kerosene; stainless steel - mixed kerosene; hard plastic - dry oil. Be sure to select the appropriate cutting oil for complex tapping process and apply anti-rust oil for maintenance after use.
Round Threading Dies
Can process, correct or clean external threads. For tapping stainless steel, aluminum alloy, cast iron, copper, iron, aluminum, plastic, etc.. NOT suitable for tile, concrete, walls, stone, etc.
Alloy Tool Steel Die
It has high hardness, wear resistance, high hardening capacity and tempering resistance. Great for maintenance and repair work on pipes, boards and machinery.
Alloy Tool Steel Dies
- High hardness
- Wear resistance
- High hardening capacity
- Tempering resistance
Tips
The end of the bar should be chamfered 1*45 degree, and the chamfer is too large to cut in. The bar diameter should be smaller ( about 0.05mm-0.15mm) than the nominal diameter of the required thread. Excessive diameter can easily cause difficult cutting and lead to damage to the die teeth.
When tapping, add suitable lubricating oil to the cutting edge, and repeat the operation 3-4 times until the thread length is obtained. When using by hand, pay attention to even force and avoid blind force.
Donna Lewis
Reviewed in the United States on September 25, 2024
The product work perfectly and arrived on schedule time thank you
Darrell
Reviewed in Canada on July 26, 2024
Exactly what was needed
Priya
Reviewed in the United States on July 13, 2024
Used the M14x1.5 combo kit (die and stock handle) to rethread 2 damaged wheel studs on an Acura MDX. It did the job correctly the first time. Use some WD-40 spray on the damaged stud, as lubricant. Price of the combo could have been better (paid $17), but happy with the results.
Harry
Reviewed in the United States on May 30, 2024
Very well Constructed at a great price!
Barton hicks
Reviewed in the United States on March 6, 2024
Needed it to rethread. Did an amazing job. High quality
Christopher Hall
Reviewed in the United States on March 17, 2024
I purchased to fix a damaged ball joint thread and chase the threads on another for a Ford Fusion. It did its job and seems to still have more bite if needed in the future.
Lee
Reviewed in the United States on November 30, 2023
Inexpensive and did what I needed it to and received it quickly.
Recommended Products
$15.49
$ 6 .99 $6.99