Shopping Cart

Your cart is empty.

Your cart is empty.

uxcell 1/4PT Male Thread 80 Degree PP Standard Veejet Flat Fan Spray Tip Yellow 5pcs

Free shipping on orders over $29.99

$8.39

$ 4 .99 $4.99

In Stock
  • Main Color: Yellow; Material: PP
  • Package Content: 5pcs x Flat Fan Spray Tip; Product Name: Flat Fan Spray Tip
  • Weight: 12g; Dimension: 13 x 26mm / 0.5" x 1"(Hex Width*L)
  • Thread Size: 12.3mm / 1/4PT; Spray Angle: 80 Degree
  • Flow Rate: 2L/Min


Comes with a 1/4PT male pipe thread so you can screw this spray tip directly onto a pipe.
These Hypro nozzles produce an even flat fan spray pattern and feature 80 degree spray angles.
The Even Flat Fan Spray Tip is commonly found in industrial and washing applications, but they can also be used for agricultural and landscaping applications.


Chris
Reviewed in the United States on September 18, 2022
made a spray wand that’s was perf
tmdak
Reviewed in the United States on March 9, 2021
I used 4 nozzles with a 4.5gpm pump to make a spray boom. I get good coverage with the nozzles spaced 20" and about 24" off the ground. This pump could handle a 5th nozzle. The threads are loose and need an above average amount of teflon tape to seal in standard 1/4" fittings. The spray pattern is not totally even across the fan but for my application this is ok. Overall, very satisfied for the price.
Joe
Reviewed in the United States on March 21, 2021
These are described as 80 degree flat fan spray tips. As the picture shows, the ones they sent me are maybe 50-60 degree at best. Going to have to see if I can find a tip that is actually 80-90 degree, and the spray rig will then work fine with even coverage. The tips themselves seem to be good quality. As others have said, you will need some teflon tape on the threads to tighten them up as they are not tapered fittings.
ADB
Reviewed in the United States on February 7, 2021
Tested one of these at about 50 psi and measured an output of 2.1 liters/min. Fan was roughly 80 degrees wide, with the central 40ish degrees quite uniform and thin, but beyond that were some thicker and thinner areas. Swept through some lower pressures and the uniformity seemed slightly better around 40 psi.The threads are untapered. The nozzle did seem to seal ok in a 1/4 BSP tapered hole with a bit of teflon tape. The fact that it's plastic probably helped.At roughly $1.50 apiece these will be fine for many uses but there are better nozzles out there if you need a precision spray.
Azzi
Reviewed in the United States on June 9, 2020
Perfect - Just what I needed!
ESCAMILLA
Reviewed in the United States on June 15, 2019
Good quality