Your cart is empty.
Your cart is empty.
These switches snap into place so you can replace your old or damaged switches with little effort.
It is a DPST switch .
Widely applied to controlling all kinds of household appliances such as water dispenser, treadmill, coffee pot,car, truck, boat, motorhome etc..
This product is of good quality and has a one-year warranty.
samuel sanchez
Reviewed in the United States on January 28, 2025
Buena calidad
DR
Reviewed in the United States on August 13, 2024
Great switch and works as designed.
House
Reviewed in the United States on November 13, 2023
The media could not be loaded.
Daniel B
Reviewed in the United States on January 10, 2023
I used these switches to control heated and cooled seats from a 2013 Expedition to work in my 1992 Explorer. They work great.
Ira W.
Reviewed in the United States on January 30, 2022
These switches are used for a project in our RV to handle 12Volt DC power. When boondocking, we use these to switch two of our RV circuits to an auxilary battery source (actually from our toad vehicle which is a Chevy Bolt Electric car). This gives us additional power to handle our two most power hungry circuits, our furnace blower motor and our 12Volt TV, while saving our RV battery for those circuits that consume a lot less current.
M. Battenfield
Reviewed in the United States on February 16, 2021
I ordered these for a replacement of the same size switch on m ATV (an auxiliary light I installed with a same-size toggle switch). This switch feels better-made and of course, it lights up when on - to help me remember to turn it off when I'm done. Switch seems well-made and was an easy swap.
Customer
Reviewed in the United States on December 10, 2021
These switches work great. I replaced the chute button on my Snow Joe snowblower and this switch makes it much easier to operate with gloves. The only surprise - these switches do not return to center (off) when you let go. You click it one direction and it stays there until you manually return the switch to the center. Not a problem for me, but could be for someone else.
Uno123
Reviewed in the United States on December 28, 2020
These worked just fine. Seem pretty well built. I had a similar issue as one of the other reviewers, prior to install, when testing with a multi meter (It seemed like it wasn't wired internally to light up). After wiring the (+) 12V side, I first attached a (-) ground to the center post on the opposite side. The light would stay on, even on the "off" position. If you want the lights to come on when switched, only attach the ground to the top an bottom terminals and leave the center post with no connection. Hope the attached wiring diagram helps.
Recommended Products
