Your cart is empty.
Your cart is empty.Set of 32 Tornado rod bearing halves for Tornado foosball tables. Complete set of bearing halves for one table. Must be used with bearing nut (not included).
Loren Jones
Reviewed in the United States on October 12, 2023
Fit right good cost fast delivery
Bobby
Reviewed in the United States on December 28, 2019
There are absolutely no bearings in this product. It is simply a piece of plastic. The rod will simply slide in and out of this plastic whole piece. Again, there are no bearings in this product.
Lane Sowers
Reviewed in the United States on December 11, 2019
Split bearings for tornado. Works great no problems.
Glenn’s Site
Reviewed in the United States on October 25, 2019
Thanks
Phil in MN
Reviewed in the United States on November 13, 2017
Super fast shipping BUT these bearings do not fit ALL tornado tables. These bearings and bearing nuts did not fit my Storm 2 table.I had to return them.
Peachy
Reviewed in the United States on August 6, 2014
Exactly as pictured and ordered. I replaced the bearings on a "brown marble" coin-op from the 80's, and it really helped. However, I might have bought the full upgrade kit if I had to do it all over again because now I want the newer men (harder/faster/slightly changed hatch patterns) and the newer flat transparent tape (which these "thin-wall" bearings were designed for and completely changes how ball reacts to hitting side wall) but I don't need another set of bearings.That said, if I wasn't changing anything else, it really helped. I had slack in the bar play at the bearings before and now its tight/like new.
Erik Mcclain
Reviewed in the United States on March 7, 2014
I recently purchased a used Tornado Table that was a bit worn dorn. I took apart all the rods and replaced all the bearings and damaged men. I had no issues with the assembling the new bearings and the split design means you can put them in place after you thread in the rod so you don't scratch the Bearing. I was also able to reuse the old bearing nuts with no issue.After reassembling the rods I applied the recommended oil and the rods now slide like the table was brand new. I highly recommend this if your table needs a little reconditioning.
Joe
Reviewed in the United States on February 28, 2013
These are nice bearings but I had to clean up the threads on every one. Threads had areas on everone where it looks like the mold is faulty.
Recommended Products
