Your cart is empty.
Your cart is empty.Time-Sert M12x1.5 repair kit with 9.4mm inserts & tapguide p/n 1215C, Includes Drill, Counterbore, Tap & Tap guide, Install Driver, 5 inserts 9.2mm, Time-Sert is Made In USA
none
Reviewed in the United States on June 21, 2024
works like it should
E. claros
Reviewed in the United States on May 22, 2024
I used my Time Insert for an oil pan on my motorcycle, the oil drain became stripped. The time inter was easy to used and install. It works great
B. Cortez
Reviewed in the United States on December 4, 2024
This saved a 14 hour job replacing an oil pan on a BMW. Absolute life saver!
DAN
Reviewed in the United States on November 13, 2024
Drain plug M/C.
Jake
Reviewed in the United States on April 16, 2024
Worked great for my drain plug on 08 renegade 800r
Who's the little guy in Star Wars?
Reviewed in the United States on September 30, 2023
For use cases where you plan on using the threaded area a lot (eg oil drain plug, or other commonly accessed threaded hole) I think time-serts take the cake. Other products like Heli-coils are great for certain uses, but when you need bulletproof reliability I prefer time-serts. The kit is great, the tap, bit, counter-sink tool, etc., are great and I've used them more than once without issue.I've had two time-serts holding my flywheel on my track car for over 8 years now with no issues. Just added another to my oil pan's drain plug. No issues, very easy to install.
LL
Reviewed in the United States on May 6, 2023
I recently found myself in quite bad situation when the threads on my motorcycle's oil pan were stripped. I knew I needed a reliable and effective solution to get back on the road.The kit arrived promptly and included everything I needed to repair the stripped threads. The detailed instructions made the process a breeze.
clfknit
Reviewed in the United States on October 9, 2022
When the previous owner of my R1200GS swapped the drain and fill plugs on my final drive, the result was two destroyed sets of threads. So the choice was a $2100 final drive, a Helicoil, or the Time-sert.Since the Time-sert had no risk of a metal tab getting loose in the final drive, and the inserts are hardened vs wire, decided it was worth the extra money (5x more money....) to get it.Man, am I glad I did! The quality of the tooling was absolutely exceptional. We used a hand driver to drill the hole (very tight tolerances to the internal gears) and went very slow (20-30 minutes) on the first one. Went in flawlessly! The insertion tool rolled the bottom threads, and the counter bore really assured a clean set. The second one went faster (10-15 minutes) since we knew what we were doing and it was flawless.Can't tell you how impressed I am with Time-sert. Never going back to a cheap wire coil!
Recommended Products
