Your cart is empty.
Your cart is empty.Taylor Cable 42502 Black Wire Loom Kit
John Waters
Reviewed in the United States on January 10, 2025
Design was ok. It was what I was looking for but everything was plastic. How long in the engine compartment with is this plastic going to last before coming brittle. Again it’s plastic
Sammy Miami
Reviewed in the United States on April 21, 2024
Due to my short tube headers being higher than normal, I could not use my original billet spark plug holders. These work perfect and look really nice!
Robert
Reviewed in the United States on August 16, 2023
These work well, be very careful with the small nuts, easy to lose. This is a solid system for vertical routing of wires I had 8mm and they fit nicely.
Ron Thompson
Reviewed in the United States on August 12, 2023
Been using these for 15 years,clean imstall.
Customer
Reviewed in the United States on February 11, 2022
Works great keeping my plug wires neatly ran to the distributor. I've use a couple other products in the past that I didn't care for.
RetroSteel
Reviewed in Canada on September 17, 2020
Used these holders and custom brackets for a flathead
Daniel Tubbs
Reviewed in the United States on August 1, 2019
Nice quality kit, easy to set up. The bolts are long but would be perfect for aluminum valve covers. I trimmed them and installed the kit on my 409.
Rev RV
Reviewed in the United States on November 5, 2018
This worked great to keep the plug wires exactly where I want them. They included all the hardware you need including plenty of bolts.The only downside I've found is that due to the different materials response to heating & cooling (cast block, aluminum heads, composite Taylor loom), I've had to retighten the bolts after every drive. It's only been 4 drives and 300 miles, so maybe everything will seat soon.
Mike B
Reviewed in the United States on July 7, 2016
As another reviewer mentioned, the bolts may be too long. I am currently using the factory stamped steel valve covers and the bolts were to long by about an 1/8 inch. If you have aluminum valve covers these bolts should work fine.
Recommended Products
