Your cart is empty.
Your cart is empty.Protect your floor and prevent screeching noise while moving your furniture here and there with our deluxe Wrought Iron Chair Glides, made with heavy-duty plastic and a wrought iron frame. Designed to fit a 1-1/2" inside diameter cup, these chair leg floor protectors allow you to enjoy and relax on your outdoor furniture without worrying about damaging patio furniture and flooring. These floor protector chair glides are available in both white and black colors and are incredibly easy to install. Before ordering these chair glides, make sure to correctly measure the inner diameter of the furniture's cup. The round furniture sliders protect your patio furniture and floor against harsh scratches and damage with our wrought iron chair leg floor protectors. Built to last longer, our sturdy and premium chair leg caps are a must-have for your patio floor.
MJM
Reviewed in the United States on February 13, 2025
Good fit.
Shroppie
Reviewed in the United States on August 27, 2024
Works great on my wrought iron set
Wicky Woo
Reviewed in the United States on June 6, 2024
Great sturdy quality. Pounded them in with a rubber mallet and they fit nice and tight. None broke or chipped with the mallet.
K. A. Sportman
Reviewed in the United States on June 16, 2024
Purchased these to replace the feet on 25 year old Patio Plantation Patters iron outdoor chairs and tables. They are a perfect fit and were easy to install.
Lou N.
Reviewed in the United States on May 4, 2024
We have a lot of wrought iron furniture and I had always used the standard white glides. These are so much easier to install and they seem to last longer as well. The design fits over the edge of the cup so there's more material where it counts.
Customer
Reviewed in the United States on October 2, 2022
Very tight, doubt they will come loose. Most leg "foot" openings are a tight fit: you have to hammer the caps on. I found that it helps to get a small piece of 80 grit sandpaper and sand out the opening on the "foot". Some openings will still be a fraction of an inch too small for the cap. What I did for these was take a Dremel with the attachment that looks like a small drum with sandpaper around it and sand down the cap a bit. Especially the bumps in the ring of the cap that hold it in tight. Even without these bumps, the cap seats very tight. Probably never come out.Also, the plastic caps appear very tough. I'm thinking they should last a decade.
Mark E
Reviewed in the United States on March 22, 2021
My inner diameter of furniture legs measured just under 1.5" but these fit perfectly on my iron bistro table and chairs. I tried using a rubber mallet but the glide kept popping off. So I placed the glide on the leg and set the chair down and applied downward pressure and then gave it a good jam and it went on perfectly. Only one was difficult to put on but that was because the inner part of the leg had a small defect so I sliced a line in the glide and jammed it on. Snug fit, glides easily on my cement patio and seems thick enough to last a few more years.
G Hutchings
Reviewed in the United Kingdom on September 29, 2019
Despite mixed reviews we found these very easy to put on the feet of our patio chairs. Hopefully they will prevent rust marks on the paving.
Albert
Reviewed in the United Kingdom on September 10, 2019
Useful in garden
Raj B.
Reviewed in the United Kingdom on July 14, 2019
It was a bit of a tough fit but one in it looks great and does the job
Customer
Reviewed in the United Kingdom on June 22, 2019
Just what I imagined and did my job. Thanks
S. Garland
Reviewed in the United States on June 2, 2019
VERY difficult to get on. Took me over an hour for 2 chairs. Absolutely tested my patience. In the end I had to boil them to get the soft enough to get on. And that still wasn’t easy. My hope is that they stay on since they were so difficult to install. But, they glide on my floor nicely. Fingers crossed, they don’t pop off.
Recommended Products
$179.99
$ 76 .99 $76.99