Your cart is empty.
Your cart is empty.Product Description
RAINPAL(by OLDEGG USA) Designing Quality Rain Barrel Parts Since 2013
Matching Step Drill Bit Available: RAINPAL SDB125 a.co/d/iQ30Gv7
Three large steps(7/8", 1-1/16" and 1-1/4")(8mm Height), works for most RAINPAL Products.
For RAINPAL SSBF020, Please use the 2nd step(1-1/16")
Step drill bit makes cleaner hole with no or minimum burs.
Use with power drill for more control. Impact drive will be too aggressive.
Designed to use on Plastics. Will not last long on steel.
Click "Visit the RAINPAL Store" then "FITTING_ETC" to purchase or use this link: a.co/d/iQ30Gv7
C. R. Crowell
Reviewed in the United States on January 18, 2025
This plastic valve requires a 3/4 inch NPT thread, but until now every single stainless bulk head fitting ordered from Amazon had had straight threads (NPS even though the product descriptions read NPT).Hallelujah!!!
Customer
Reviewed in the United States on December 9, 2024
The reverse threads made it REALLY convenient. Used it to make a return inlet for hydraulic reservoir. Pleased.
Customer
Reviewed in Canada on August 5, 2021
Good quality & arrived ahead of schedule.
Johnny matta
Reviewed in the United States on July 14, 2020
They were great! I used them to create ports on regular steel trash cans. Then I added stainless steel ball valves. They turn a clean steel barrel into excellent rain catching/dispensing container.
Nick
Reviewed in the United States on May 16, 2020
The only issue I had was the low quality surface finish and them being shipped with cheap silicone seals. The seal holds water in but I’d replace it with something else like a slightly thicker, same diameter buna, nitrile, etc. seal and you’ll be good to go. Especially when using with various chemicals and hot liquids. I would carefully question the lifespan of the stock seals. The threads on mine were higher quality but the faces of them were scratched up. Higher quality metal and threading with lower quality parting off causing poor top / front face surface finish. Of course, as with anything made in China, your results may vary.
John
Reviewed in the United States on December 6, 2020
I'm planning to use these for the inlet valves on an ugly drum smoker, so sealing fluid in isn't critical. I built rain barrels previously and these bulkhead fittings would have made it easier. I think it's a great deal, and the workmanship was fine. You need to know the outside thread is reversed, so you can't put the flush end out or else when you tighten the inside pipe/fitting/hose bib it will loosen up on you.
blackdog
Reviewed in the United States on September 10, 2019
These little beauties solved my problem of how to make a Rain Barrel from a garbage can. No more than five minutes to install. Had our first big rain last night. Now I have 30 gallons of rain water to water the plants,
Gary
Reviewed in the United States on August 26, 2019
Good solution to convert my Type 1 range hood to a Type 2 condensate hood for my home brewery. I needed a spigot to drain the liquid condensate from the rear pan. Its got threads on the outside and inside. I added an MNPT to barb fitting which goes to a bucket at the end of a boil.
Gregory Blauser
Reviewed in the United States on October 27, 2019
Used these to put drains in two barrel halves for beer baths, Worked like a charm,
Recommended Products